User manual AEG-ELECTROLUX UZ 930 S

[. . . ] See instructions for servicing of double insulated appliances. WARNING ! To reduce the risk of fire, electric shock, or injury, please read and follow all safety instructions and caution markings before use. This vacuum cleaner is designed to be safe when used to for cleaning functions as specified. Should damage occur to electrical or mechanical parts, the cleaner and / or accessory should be repaired by the manufacturer or competent service station before use in order to avoid further damage to the machine or physical injury to the user. · Do not use outdoors or on wet surfaces. [. . . ] Press the membrane over the flanged edge on the inlet. Warning! Never attempt to vacuum liquid, glass fragments or ashes!Wet surfaces can expose the operator to possible electrical shock. 3. Hose connection Push the hose coupling all the way in and turn clockwise. 9. Filter The filters are located inside the lid. To reach them lift out the filter holder(a). The standard filter(b) and fine filter (c) should be inspected at regular intervals, e. g. when you change dust bags, and replace if necessary. Instead of these two filters you can fit a micro filter of HEPA-quality (e), wich traps 99, 99% of all particles larger than 0, 3 microns. The machine is also fitted with a backupp filter (d) located above rhe motor. This filter should also be inspected and replaced if necessary. 4. Wand assembly Standard: Fit the sections together and twist to lock in place. Telescopic: Push down the catch and then adjust the length. Tools The accessories shown in the pictures may vary from model to model. a-b)Combination nozzle Adjust the nozzle according to the requirements of the floor you are cleaning. Work with the brush on hard floors and without it on soft floors. c)Universal nozzle for both hard floors and carpets. d)Crevice nozzle Use to clean furniture, radiators and others hard-to-reach places. e)Small combi-nozzle: The small combi-nozzle combines a dusting brush for furniture, picture frames, mouldings etc. with a fold-out nozzle for cleaning curtains, furniture and other soft surfaces. The clip on the hose handle holds the nozzle when it is not in use. g)Carpet nozzle with thread pick-up To use the thread pick-up, turn the nozzle. IMPORTANT! The UZ 930S/S2 is equipped with a specially designed cable, which if damaged, must be replaced by a cable of the same type. These cables are avaible at authorized service shops and must be installed by trained personnel. [. . . ] The plug thus cut off MUST BE DESTROYED for safety reasons before being disposed of. Machines built for other voltages and frequencies are not normally supplied with a fitted plug. If it is necessary to fit a plug, the wires in this power supply cord are coloured in accordance with the following code: BLUE-NEUTRAL BROWN-LIVE To connect the new plug: The wire which is coloured green & yellow must be connected to the terminal in the plug which is marked with the letter 'E' or by the safety earth symbol or coloured green or green & yellow. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter 'N' or is coloured black or blue. [. . . ]