User manual AEG-ELECTROLUX V5017.4

[. . . ] People and animals must not be vacuumed using the appliance. Keep children away from electrical appliances. The manufacturer is not liable for any damage caused by incorrect use or operation. Leave wet shampooed carpets to dry completely. [. . . ] Avoid running over the mains lead with the appliance or the vacuum brush. The insulation could be damaged. Preparing the vacuum cleaner for use The accessories can be connected by pushing and twisting, and can be disconnected by pulling them apart and twisting. Connecting the suction hose and suction tube. Join the suction hose handle firmly to the suction tube. 9 Using the nozzles Connecting the suction tubes Join the two tubes. Using the floor nozzle* For the daily care of carpets and hard floors. Without being changed over manually, the floor nozzle is entirely suited for daily vacuuming of carpets and hard floor surfaces such as parquet, tiles, linoleum, etc. Adjust the Telescopic Tube (depending on model) Using the floor nozzle* For the daily care of carpets and hard floors. The floor nozzle may be changed over manually. The brushes can be extended for smooth floors and retracted for carpets. Attaching the suction hose Insert the suction hose connector in the suction inlet. It locks in place and can be rotated all the way around. Press the release button and pull out the connector in order to remove the suction hose. Mains connection/Cable rewind The mains cable is in the cable compartment. Pull out the cable and insert the plug into the mains socket. Press the foot button; the cable rewinds automatically when vacuuming has been completed. Crevice and upholstery nozzle stored in the appliance For specific cleaning requirements, two additional parts are included with the vacuum cleaner in an integrated accessories compartment*. Open the compartment by pressing gently as shown in the figure. The nozzles may be attached to the suction tube or the handle on the suction hose, depending on requirements. 10 Maintenance and cleaning Prior to maintenance or cleaning, ensure that the appliance is switched off and that the mains plug has been removed from the socket: Crevice nozzle For vacuuming crevices, gaps and corners. Upholstery nozzle For vacuum cleaning all upholstered furniture, mattresses, etc. The thread lifting strips on the nozzle even pick up thread and lint. Changing the paper filter The paper filter must be replaced if the window on the filter replacement indicator is completely red when the appliance is operating at maximum power and the nozzle is raised from the floor. The paper filter should be replaced even if it does not appear to be full because fine dust can block the pores in the surface of the filter. Switching on Switching on and off You can switch the appliance on and off by pressing the On/Off button. Power adjustment: The cover can be opened by pressing the button and folding back until it locks. Power adjustment - Rotary control* The suction power can be varied to suit individual vacuuming requirements using the electronic power adjuster. Hygienic filter change: When removing the full filter bag, pull the closing tab to automatically close the opening. There will be slight resistance when the tab is pulled. *depending on model 11 Bags full of normal household dust may be disposed of with household waste. Insert the new paper filter as far as it will go in the guide rails; only then can the lid be closed. The cover cannot be closed unless a paper filter has been inserted. Changing the microfilter We recommend replacing the microfilter at each fifth paper filter replacement, and at the latest when there is a clean dust bag and the dust level indicator is completely red with the nozzle raised. Paper filter VAMPYR Seria 5. . . /COMPACT E-Nr. 668. 901. 268 Paper filter size 28 Carrying and Storage To make the appliance easier to store and carry, slide the floor nozzle into the tool rail. Remove the used microfilter by means of the clean hygienic tabs (figure) and dispose of it with the household waste. Insert the new microfilter and close the cassette. Parking System For storing the suction pipe and nozzle during short pauses in vacuuming. [. . . ] Check paper filter bag, suction tube and suction hose; remove any blockage. The appliance can be switched on again after approximately 30 minutes. 12 . . . the fuse has blown The fuse may blow if you use other electrical appliances with high power consumption on the same electric circuit at the same time as the vacuum cleaner is in use. This can be avoided if you set the electronic power adjuster to the lowest power level and then select a higher level after switching the appliance on. [. . . ]