User manual AEG-ELECTROLUX VAMPYR5093.0

[. . . ] Common sense and caution must be practiced when installing, operating, and maintaining any appliance. Do not remove any prong from the power cord. Do not, under any circumstances, cut, remove, or bypass the grounding prong. Destroy the carton, plastic bags, and any packing materials immediately after the dehumidifier is unpacked. [. . . ] The dehumidifier must be installed on a level floor that will support it with a full bucket of water. There should be a minimum of 12 inches clearance around the dehumidifier. HOW IT WORKS When the unit is started, the fan begins to pull moisture-laden air across the dehumidi- The coils condense or draw moisture from the air, and air flows through the side louvers into the room as dry, warm air. Moisture removed from air is collected in a bucket on the front of the dehumidifier. The unit is designed to operate between 5°C (41°F) and 35°C (96°F). The unit will not work properly if the temperature is out of this temperature range, or the performance of the unit will fall greatly. The "Compressor" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. this prevents overheating of the compressor and possible circuit breaker tripping. Make sure the tank is fitted correctly otherwise unit will not turn on. Allow the unit to reach room temperature before operating. To begin operating the dehumidifier, follow these steps: Unit must be upright for one hour prior to operating. ­ Before entering TIMER setting, make or sure pressing HUMIDITY button sets one desired room humidity first. The CLEAN FILTER light will illuminate after 250 hours of operation. At this time refer to the care and cleaning section to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the FILTER butto extinguish the light. To shut the unit down, press the ON/ OFF button . Emptying the Bucket: ­ When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate. ­ Do not move the unit at this time otherwise water may spill on the floor. Press sides of bucket gently to unclip the bucket from the unit. ­ Remove the bucket as shown in the photographs below and empty the bucket. ­ Replace the empty bucket back into the unit and once seated correctly, the unit will start up again. ­ You should hear a click when the bucket is in the correct position Warning! [. . . ] STORAGE When unit is not in use, unplug and use the cord wrap shown for your model type. Before calling for service, review this list. This list includes common occurrences that are not Push plug firmly into wall outlet. Dehumidifier automatically shuts off when selected amount of moisture has been removed from the air. [. . . ]