User manual AEG-ELECTROLUX VAMPYRMULTIPRO3IN1

[. . . ] VAMPYR® Multi 3 in 1 VAMPYR® Multi PRO 3 in 1 Nass- und Sprühsauger Wet and spray vacuum cleaner Aspirateur par voie humide et pulvérisation Zuigapparaat voor natzuigen en sproeizuigen Gebrauchsanweisung Operating instructions Mode d'emploi Gebruiksaanwijzing 32 A = Motor head B = Rotary switch C = Rocker switch D = Quick disconnect coupler E = Hose connection F = Dust container G = Guide rolls H = Suspension pin / Stop position I = Vice action latch J = Cable K = Carry handle with cable cradle L = Suction tube or telescope tube, depending on design M = Flexible pressure tubing N = Shut-off valve O = Suction control P = Clip Q = Suction hose R = Motor protection filter S = Foam filter T = Fine paper filter U = Tension ring V = Paper filter W = Detergent tank 1 2 3 4 5 6 7 = Spray suction nozzle for carpet = Hard flooring adapter = Spray suction nozzle for upholstery = Universal flooring nozzle = Groove nozzle = Upholstery nozzle = Vacuuming brush 33 Contents Description of appliance . 33 35 37 38 42 45 52 53 56 Dear customer, Please read this instruction manual carefully. Above all, please observe the safety instructions located on the first few pages of this instruction manual. Please retain this instruction manual for later reference. [. . . ] Empty the dust container and clean it and the components used with warm soapy water and let them dry; in particular this should be done after vacuuming up sticky liquids. Prior to being reassembled, all appliance parts must be totally dry. Coil the cable in large loops and hang it on the cable cradle located on the carry handle. The vacuuming pipe can be hung on the mountings on the motor head together with the nozzle and hose. 0 0 45 Spray vacuum cleaning 0 Only spray vacuum those surfaces and upholstery which are suitable to be wet vacuum cleaned. Do not wet fragile hand-woven carpets or carpets which are not colour-fast. Caution: When spray vacuum cleaning be sure to use only AEG detergent with foam inhibitor for spray vacuum appliances. 0 Preparation: Prior to treating a carpet for the first time, test the fastness of the colour by applying some detergent concentrate to a white cloth and rub it onto a patch of carpet that is not so visible. If no traces of colour remain on the cloth, the carpet can be cleaned using water. In any other event, do not use water when cleaning the carpet. Prior to spray vacuum cleaning carpets, thoroughly vacuum the entire area in order to remove any loose dirt in advance. Before commencing spray vacuuming always remove the paper filter and the foam filter. Pour water and detergent concentrate into the detergent tank: 20 ml detergent concentrate per litre of water. Use only lukewarm water, as higher temperatures could damage the appliance and carpets and upholstery. Place the detergent tank inside the dust container. To draw up the cleaning liquid out of the tank, free the thin hose located on the motor head from where it has been fastened. Then attach the motor head on the dust container such that the switch is located vertically above the suction hole. When doing this, ensure that the thin hose is immersed in the cleaning liquid. Then press the two vice action latches. 0 0 46 0 Connecting the vacuuming hose, pressure hose and vacuuming pipes Insert the hose inserts into the suction hole as in the picture and turn it to the right until it locks into place. To remove the vacuuming hose, twist the hose inserts to the left and remove. Then firmly press the end of the thin pressure hose into the quick disconnect coupler located on the motor head until the coupler clicks into place. Press the pressure hose into the clips and secure these to the vacuuming hose such that they are evenly spaced. 0 0 At the other end of the vacuuming hose connect the two vacuuming pipes to the handle, by first connecting the pipe without hook-in pins and then the one with pins. Insert the shut-off valve located on the pressure hose into the track located on the upper vacuuming pipe as far as it will go. Then turn the vacuuming pipe such that the shut-off valve is located on the underside of the handle. [. . . ] · Are the filter pores blocked by fine dust or grime?· Are the nozzles, extension pipe and vacuuming hose blocked by dust?· Is the motor protection filter soiled?. . . the suction power suddenly decreases? [. . . ]