User manual AEG-ELECTROLUX WE 2000 E

[. . . ] Your new water purifier THANK YOU for entrusting us to supply your new water purifier. We are confident it will provide you with many years of trouble-free use. The advantages of the water purifier include: q q q q q q q q high capacity direct flow continuous measurement of the water quality no water tank needed no chemicals added high purification level simple installation and easy maintenance attractive and compact design To avoid problems, it is important for you to read the user instructions. Read the «Safety information» and the «Installation» instructions especially carefully. [. . . ] Put the filter container back in accordance with «Replacing the filter», points 8 - 9. Mix 2 litres of preserving agent and 2 litres of water in a bucket. Insert the feed water hose in the mixture, making sure that the mouth of the hose is constantly below the surface level of the liquid, see fig. The water purifier now draws the mixture into it. Stop the production of pure water once all the liquid has been fed into the water purifier. The noise produced by the water purifier changes during the first few seconds. Disconnect the feed water hose from the water purifier. 5. The water purifier is put into storage and can be kept in this way without the risk of freezing. On reinstallation, the water purifier should: q stand somewhere where the temperature is above +5° C for at least 48 hours. be supplied with a new filter, see «Replacing the filter». be flushed in order to wash out the preserving agent, in accordance with «Flushing». Don't forget to insert a new filter in the water purifier. q q - 11 - Maintenance Cleaning the grid The grid blocks larger particles and is situated in the feed water connection. If the flow is reduced or the purifier makes a noise, the grid may be blocked. Check that the water purifier is in standby mode. Close the shut-off valve at the feed water connection. Unscrew the feed water hose from the water purifier. Using pliers or similar, grip and pull out the grid in accordance with fig. Remember which way the grid is installed. Reinsert the grid in the feed water connection using the pliers. Open the shut-off valve at the feed water and check that there is no leakage. G 5. 6. 7. The grid is now clean and the water purifier is ready to be used. Regular care of the water purifier Listed below are things you need to remember in the regular care of your water purifier. The points are listed according to how often they need to be performed: q Every day, check that the indicator lights are not indicating that something has to be attended. Externally, the appliance may only be cleaned with a damp cloth. [. . . ] Check that the seal is in place in the connection. Open the shut-off valve on the feed water and check that there is no leakage at the feed water hose. 2. Pure water The pure water is routed via the pure water hose to the faucet installed on the sink unit. Connect the pure water hose from the pure water faucet to the water purifier. Push the hose into the bottom position, up to the mark (approx. [. . . ]