User manual AEG-ELECTROLUX WTSL4E200

[. . . ] Safety information Environment concerns Technical information Product description Control panel Programmes Consumption values Before first use Using the appliance - Washing only Loading the laundry 2 4 5 5 6 10 14 14 14 14 Filling the detergent and additives Setting and starting a programme At the end of the programme Using the appliance - Drying only Using the appliance - Washing & Drying 15 16 17 17 Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge use the appliance. [. . . ] Always obey the instructions that you find on the packaging of the detergent products. Pull out the detergent dispenser until it stops. To use powder detergent, turn the flap up. To use liquid detergent, turn the flap down. With the flap in the position DOWN: ­ Do not use gelatinous or thick liquid detergents. ­ Do not put more liquid detergent than the limit showed in the flap. Make sure that the flap does not cause a blockage when you close the drawer. The display shows the default temperature, the spin speed and the empty indicator bars of the available functions. The drain pump can operate for a short time when the appliance fills water. The appliance adjust automatically the cycle time to the laundry you have put in the drum to have perfect washing results in the minimum necessary time. After approximately 15 minutes from the start of the programme, the display shows the new time value. CHANGE A FUNCTION You can change only some functions before they operate. Press button 7 again and again until the display shows the number of minutes or hours. When the countdown is completed, the programme starts automatically. Before you press button 6 to start the appliance, you can cancel or change the set of the delay start. You cannot set the delay start with the Steam programme. Press button 7 again and again until the display shows 0'. Now, you can set a new washing programme. The door lock symbol in the display goes off. If the temperature and level of the water in the drum are too high, the door Lock symbol stays on and you cannot open the door. If you deactivate the appliance, it is necessary to set the programme again. After five minutes from the end of the programme, the energy saving function automatically deactivates the appliance. [. . . ] Follow the instructions supplied with the kit. Remove the polystyrene piece from the door seal and all the items from the drum. Put one of the polystyrene packaging elements on the floor behind the appliance. Carefully put down the appliance with the rear side on it. [. . . ]