User manual AEG-ELECTROLUX X 99384 MV0

[. . . ] If the extractor is used in conjunction with non electrical appliances (e. Gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. [. . . ] Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. EN - RECOMMENDATIONS AND SUGGESTIONS - The Instructions for Use apply to several versions of this appliance. Ty Product Components 11 Hood Body, complete with: Controls, Light, Blower, Filters 81 Directional Air Outlet grille 9 1 ReducerFlangeø150-120mm 10 1 Dumper 16 1 Filter cover Ref. As a first step, proceed with the following drawings: · Markareferencepoint(2) as indicated at 210 mm from the vertical reference line and 482 mm above the cooker top. 1 on the wall, about 1-2 mm from the ceiling or from the upper limit, aligningthecentre(notch)withtheverticalreferenceline. Open the top suction panel and fasten it to the hood body on the left using the pin, so that it does not close again. Unlock the lower suction panel by removing the fixing pin on the left, and open it. Adjust the two screws Vr, in the brackets 11a, so that they are at the start of their travel. Hook the hood body to the two brackets 11a. From the inside of the hood body, turn screws Vr to level the hood body itself. CONNECTIONS DUCTED VERSION AIR EXHAUST SySTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. Screw the filter cover onto the air outlet, using four screws 12c (2. Fix the directional grille 8 on the recirculation air outlet using the 2 screws 12d (2, 9 x 9, 5) provided. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. When the button is touched with the hood turned off, all functions light up (intensity 50%) and are enabled. When the button is touched with the hood in operation, all functions are turned off and disabled (Motor Off + Lights Off). When the area is touched, the motor starts at the speed required. p = Intensive Speed , timed for 5 minutes , after which the system returns to the previous speed. When activated from Motor Off it returns to speed V1. When the required speed is touched, it will become brighter (intensity 100%) than the other functions (intensity 50%). [. . . ] If the motor and lights are turned off, by setting them to zero, allthecommandLEDswillremainonat50%, andifnofurthercommandsaregiveninthenext10seconds, thenalltheLEDswillbe turnedoffwiththeexceptionofthe"0"LEDs, whichwillremainonforafurther15minutes. Two options are available: · Turn the hood off using the hood on/ off button · Remove power for 10 seconds and then reconnect it. the calibration procedure is carried out every time the type of hob is changed. Calibration procedure: every time the hood is turned on or the type of hob is changed, the sensor calibration procedure is run. [. . . ]