User manual AEG-ELECTROLUX XXLBOX1

[. . . ] After vacuuming rewind the power cord by pushing the REWIND button. (1 = MIN ; 5 = MAX) Models with display and remote control: Modelle mit Anzeige und Fernsteuerung: Follow the numbers for optimal performance. (1 = MIN ; 5 = MAX) Für optimale Leistung den Nummernangaben folgen. (1 = MIN ; 5 = MAX) Curtains Vorhänge Bookshelves, upholstery, crevices, corners Bücherregale, Polster, Fugen, Ecken 3in1 Delicate carpets Empfindliche Teppiche Brushes up Borsten eingezogen 3in1 Rugs Vorleger Brushes up Borsten eingezogen Hard floors Hartböden Brushes down Borsten ausgefahren Attention: on fur rugs, rugs with long fringes or deep pile exceeding 15 mm the motorized nozzle should have the brush roller off. [. . . ] Open the dust container by pushing the release button downwards. Hold the container over the waste bin and empty it completely. Remove the cyclonic filter by pulling out the filter grip. Let it dry completely before putting it back into the dust container. Put the dust container back until it clicks into place. Replacing / Cleaning the exhaust filter Austauschen/Reinigen des Abluftfilters 9 Cleaning the washable exhaust filter Wash the filter every three months. If the filter is damaged, replace it with a new filter. rinse the inside (dirty side) in lukewarm tap water. Tap the filter frame to remove the water. Note: Do not use cleaning agents and avoid touching the filter surface. Let the filter dry completely before putting back !The vacuum cleaner stops • Check if dust container is full. If so, empty it and clean both the dust container and the filters before putting it back in the cleaner. • Check if the nozzle , tube or hose is blocked. € Check the motor and exhaust filter are clean. The cleaner stops The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube or hose are blocked. Let the cleaner cool down for 30 minutes before plugging it in again. If the cleaner still does not work, contact an authorized AEG service centre. • Check if the nozzle , tube or hose is blocked. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorized AEG service centre. [. . . ] € If the cord is damaged, it must be replaced only by an authorized AEG service centre in order to avoid a hazard. Damage to the vacuum cleaner’s cord is not covered by the warranty. € Never pull or lift the vacuum cleaner by the cord. all servicing and repairs must be performed by an authorized AEG service centre. [. . . ]