User manual AEG-ELECTROLUX Z1170

[. . . ] · Insert the hose until the catches click to engage. · Attach tubes or telescopic tube to the hose handle and floor nozzle by pushing and twisting together. · Extend the cable and connect to mains. Mondo is fitted with cable rewind, ensure cable is not twisted before use. Ensuring your safety The Electrolux Mondo is for domestic use only and has been designed to ensure maximum safety and performance. [. . . ] Use the Turbo nozzle which is ideal for picking up hair and fibres and for grooming your carpet. Hard floors: Use the floor nozzle with the lever in this position. Loose rugs/curtains/lightweight fabrics: Reduce the suction power. Use the floor nozzle for loose rugs and the upholstery nozzle for curtains, cushions etc. Lamps, pictures and bookshelves: Use the dusting brush. Confined areas: Use the crevice nozzle for crevices, corners and radiators. Dust bag indicator and changing the dust bag For peak performance the dust bag must be changed when full. If the dust bag should accidentally get broken in the cleaner, take cleaner to an Electrolux Service Centre for cleaning. Check the dust bag regularly and replace when necessary. The dust bag indicator window will gradually turn red when filling and completely red when full / the electronic indicator will flash every half second when full. To check the dust bag, the cleaner must be switched on, with all attachments connected and off the floor. Water: If water is sucked into the cleaner the motor must be changed at an Electrolux Service Centre. If you have any comments on the cleaner or the Instructions for use Booklet please e-mail us on: floorcare@electrolux. se 54 English Electrical supply (UK and Ireland only) Before you start . . . check the voltage Before connecting the cleaner to an electrical supply ensure that the voltage marked on the data plate (on the underside of the cleaner) is correct for your electrical supply. If it is not, do not use the cleaner but refer back to your dealer. of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home. The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-andyellow. This cleaner is double insulated and no earth connection is necessary. It is in your interest to ensure that the plug is correctly attached to the mains cable. [. . . ] It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee. Connecting to your electricity supply Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse and the fuse cover must be replaced before the plug is used again. [. . . ]