User manual AEG-ELECTROLUX Z1181

[. . . ] · Press the On/Off foot pedal to activate the cleaner. · To reduce suction, gradually open the aperture on the hose handle. Slide the electronic suction control between `MAX' and `MIN' / press the `-/+' foot pedal. A B C D E F G H I J K L M N O P X Mains cable Your Mondo features Cable rewind pedal Electronic suction control Steptronic suction control Electronic dust bag indicator Power outlet (for the use of power driven tools) cal dust bag indicator Tools for your Mondo A Dust bags Extension tubes (x2) Telescopic tube Swivel hose and handle with manual suction control Combination carpet/hard floor nozzle Turbo nozzle Narrow crevice nozzle Upholstery nozzle Dusting brush Small tool holder tool holder B C D B F G H I J KLarge For Aust/NZ: We recommend you do not use your vacuum on carpet cleaning foams or to clean up building materials including 'gib' or plaster dust. [. . . ] C Insert new dust bag by fitting the bag slots over holders. We recommend the dust bag is changed: * after using a carpet cleaning powder * if there is a bad smell from the cleaner, then you should also change the filter Note: Use only Electrolux original dust bags and filters (ref E44) Dust bag safety device To avoid damaging the cleaner do not use it without a dust bag. A safety device is fitted which prevents the cover closing without a dust bag. Changing the filters These should be changed with every fifth dust bag. Never use the cleaner without the motor protection filter. To change filters: a) Lift lid, remove dust bag and filter. b) Insert new filter, replace dust bag and close. To change it: a) Lift rear grill and remove filter. b) Insert new filter and replace grill. Troubleshooting 1. Power: If the electric power does not come on, disconnect from mains and check plugs, cable and fuses where appropriate. Blockages/dirty filters: The cleaner may switch itself off in the event of a severe blockage or excessively dirty filter(s). In such cases, disconnect from mains and allow to cool for 20-30 minutes. Clear blockage and/or replace filter(s) and restart. The clearing of blocked hoses is not covered by the guarantee. To avoid blockages and maintain suction efficiency, the floor nozzles should be cleaned regularly using the hose handle. Disconnect from mains and check the turbo nozzle for threads entangled in the brush roller. [. . . ] If difficulty is experienced in obtaining a replacement, contact your nearest Electrolux Service Centre. (Please see the separate Electrolux Service Organisation leaflet). In no circumstances must the plug be used without a correct fuse cover fitted. [. . . ]