User manual AEG-ELECTROLUX Z1910

[. . . ] Attach extension tubes or telescopic tube to the hose handle and floor nozzle by pushing and twisting together (Twist and pull apart to dismantle). Swivel hose and handle with manual suction control Combination carpet/hard floor nozzle Narrow crevice nozzle Cable rewind pedal Power outlet (for the use of power driven tools) (some models) Electronic suction control (some models) Mechanical s-bagTM indicator Hose connection s-bagTM security device ­ prevents lid closing without a s-bagTM in place Carrying handle Cover release catch for s-bagTM compartment On/off switch Storage slot for floor nozzle and extension tubes when in use Storage slot for floor nozzle and extension tubes when not in use The Electrolux Clario is for domestic use only and has been designed to ensure maximum safety and performance. The Clario is only to be used by adults Always store in a dry place Do not use to pick up liquids Carpets: Use the floor nozzle with the lever in this position. [. . . ] wooden floors: Use parquet nozzle to avoid scratching (some models). Low furniture: Use ultra low nozzle for better clearance (some Avoid sharp objects Do not pick up hot cinders or lighted cigarette ends Do not use near flammable gases Avoid tugging on the mains cable and check cable regularly for damage Note: Do not use your cleaner with a damaged cable. If damaged the cable should be replaced at an Electrolux Service Centre The Plug must be removed from the socket-outlet before cleaning or maintaining the appliance All service and repairs must be carried out by authorised Electrolux service staff Use the floor nozzle for loose rugs and the upholstery nozzle for curtains, cushions etc. S-bagTM safety device To avoid damaging the cleaner do not use it without a dust bag. A safety device is fitted which prevents the cover closing without a dust bag. Changing/Cleaning the filters These should be changed/cleaned every fifth dust bag. Never use the cleaner without the motor protection filter. To change Motor Protection filter: D) Release catch and swing back lid. To clean HEPA filter (some models): H) Open filter cover and remove filter unit. To change the s-bagTM: A) Release catch and swing back lid. b) Pull the sliding tab to remove the s-bagTM. C) Insert the new s-bagTM by sliding the bag slots onto the holder. If there is a bad smell from the cleaner, then you should also change/clean the filters. Repeat cleaning procedure four times and allow the filter to air dry. the original filtering performance is now restored. Replace unit back into cleaner and close cover. Power: If the electric power does not come on, disconnect from mains and check plugs, cable and fuses where appropriate. Blockages/dirty filters: The cleaner may switch itself off in the event of a severe blockage or excessively dirty filter(s). [. . . ] In such cases, disconnect from mains and allow to cool for 2030 minutes. To avoid blockages and maintain suction efficiency, the floor nozzles should be cleaned regularly using the hose handle. Please also see Electrolux additional information towards the back of this booklet. [. . . ]