User manual AEG-ELECTROLUX Z2045

[. . . ] · Disconnect the plug from the mains before cleaning or maintenance of the vacuum cleaner. · Regularly check that the cable is not damaged. Never use the vacuum cleaner if the cable is damaged. All service and repairs must be carried out by an authorised Electrolux service engineer. [. . . ] 7-8 Open the filter grill to remove the exhaust filter. 8-7 Replace it with a new one and put it back into the cleaner. HEPA filter reference number: EF51b. Note: Do not use cleaning agents and avoid touching the delicate filter surface. 5 CLEANING THE HOSE AND NOZZLE The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked, or the filter and dustbag are blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters or the full dustbag. Tubes and hose 1 Use a cleaning strip or similiar to clear the tubes and hose. 2 It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. Cleaning the floor nozzle 3 To avoid reduction in suction power, frequently clean the dual purpose floor nozzle. The easiest way to clean it is by using the hose handle. 2 1 3 6 TROUBLESHOOTING AND CUSTOMER INFORMATION Troubleshooting The vacuum cleaner does not start 1 Check that the cable is connected to the mains. [This cleaner is double insulated and no earth-connection is necessary. ] It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of guarantee. As a general guide to fitting any plug · Ensure the lengths of wire inside the plug are prepared correctly. · Connection should be firmly made after all conductor stands are entered into the terminal posts. · When preparing the cable ends take care not to damage the outer seal, or insulation surrounding the inner conductors. · Replace the top cover of the plug and secure. 8 When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL THE INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: · Do not use out doors or on wet surfaces. · Do not leave vacuum cleaner when plugged in. · Do not allow to be used as a toy. Close attention is necessary when used near children. Do not allow children to operate this appliance. · Use only as described in this manual. [. . . ] It is dependent upon the appliance being correctly installed and used in accordance with the Company's instructions under normal domestic conditions within the United Kingdom or the Republic of Ireland. Service at all times must be carried out by an Electrolux Service Representative or authorised agent. The guarantee may be invalidated by unauthorised repair or modification of the appliance. You may be charged by the Electrolux Group if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet. [. . . ]