User manual AEG-ELECTROLUX Z3318

[. . . ] Electrical cable precautions: · A damaged cable must be replaced by an authorised Electrolux service engineer. Damage to the cleaner cable will not be covered by the warranty. · Never pull or lift the vacuum cleaner by the cable. · Disconnect the plug from the mains before cleaning or maintenance of the vacuum cleaner. [. . . ] Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters or the full dustbag. Tubes and hose 1 Use a cleaning strip or similiar to clear the tubes and hose. 2 It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. Cleaning the floor nozzle 3 To avoid reduction in suction power, frequently clean the dual purpose floor nozzle. The easiest way to clean it is by using the hose handle. 2 1 3 7 TROUBLESHOOTING AND CUSTOMER INFORMATION Troubleshooting The vacuum cleaner does not start 1 Check that the cable is connected to the mains. 2 Check that the plug and the cable are not damaged. The vacuum cleaner stops 1 Check whether the dustbag is full. Water has entered the vacuum cleaner It will be necessary to replace the motor by an authorised Electrolux service engineer. Damage to the motor caused by the penetration of water is not covered by the warranty. Customer Information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. This product is designed with the environment in mind. All plastic parts are marked for recycling purposes. For futher details see our website: www. electrolux. com For repairs or accessories, contact the Electrolux Group Floorcare Helpline on 08706 055 055. If you have any comments on the cleaner or the Instructions for Use booklet please e-mail us at: floorcare@electrolux. com 8 ELECTRICAL SUPPLY INSTRUCTIONS Before you start . . . check the voltage Before connecting the cleaner to an electrical supply ensure that voltage marked on the data plate (on the underside of cleaner) is correct for your electrical supply. If is not, do not use the cleaner but refer back to your dealer. Connecting to your electrical supply Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse and the fuse cover mustbe replaced before the plus is used again. In the event ofloss of the fuse cover, replacements can be obtained from your Electrolux dealer or Electricity Board and must be of the same colour as indicated by the coloured insert on the base plug. [. . . ] · Use extra care when cleaning on stairs. · Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present. · Store your cleaner indoors in a cool, dry area. · Keep your work area well lighted. [. . . ]