User manual AEG-ELECTROLUX Z3530

[. . . ] 4 Use & Assembly . . . . . . . . . . . . . . . . . . . . . . . . 6-8 Maintaining . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Problem Solving . . . . . . . . . . . . . . . . . . . . . . . . . 10 Guarantee . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 2 Important: For future reference we suggest you record the following details here, and keep the receipt with the handbook as proof of purchase. Purchased from ___________________________________________________ Date purchased _________________ Model no _________________________ SAVE THESE INSTRUCTIONS BEFORE YOU START CHECK THE VOLTAGE First check the voltage shown on the data plate (see rear view) to make sure that the cleaner is of the correct voltage for your electricity supply. If it is not, do not use the cleaner but refer back to your dealer. CONNECTING TO YOUR ELECTRICITY SUPPLY (for UK residents only) Permanently connected to the cleaner is a mains supply (3-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux dealer or Electrical Retailers and must be of the same colour as indicated by the coloured insert on the base of the plug. f difficulty is experienced in obtaining a replacement, contact Electrolux on 08706 055055. In no circumstances must the plug be used without a correct fuse cover fitted. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home. The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L orcoloured red. The wire which is coloured yellow and green must be connected to the terminal which is marked with a letter E or coloured yellow and green. It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee. Fuse Cover Yellow and Green 13 Amp Fuse Fuse WARNING Blue Brown Cord Clamp If the mains supply cable becomes damaged during cleaning the following action should be taken: 1. Some surfaces that can be cleaned with the Steam Gun are: upholstery, sealed grout, bathroom and kitchen tile, stove tops, removable exhaust filter over stoves, windows and mirrors. The fabric tool may be used to steam wrinkles out of clothing, window coverings, etc. CAUTION: Do not direct steam at the body. Other Advantages of the Electrolux Steam Gun hand held steamer The Electrolux Steam Gun can kill dust mites and some types of bacteria, such as salmonella and E-coli when used properly. To disinfect a specific area, position the steamer over the area, not more than 1 inch away and slowly move across the surface. Use this procedure to disinfect surfaces in: the bathroom, food preparation areas, pillows and bedding, pet sleeping quarters, etc. 5 INSTRUCTIONS FOR USE The Electrolux Steam Gun is designed to thoroughly clean hard surfaces and upholstery that will withstand high heat. Do not use on soft plastics, unsealed wood, and cold glass. WARNING: On surfaces that have been treated with wax or some non wax floors, the sheen may be removed by the heat and steam action. It is therefore recommended that a sample cleansing be carried out on an isolated area of the surface to be cleaned. Also, check use and care instructions from the manufacturer on the object you want to clean. PROBLEM SOLVING NOTE: Unplug the electrical cord before servicing. PROBLEM Appliance won't start CAUSE Electric plug SOLUTION Push plug securely into outlet. Check circuit breaker. Appliance won't make steam Appliance spits water out of nozzle No water in tank No water in tank Check the tank for water. [. . . ] Use special funnel provided. Water tank too hot. Attachments 4. The straight nozzle, flexible hose and fabric tool all attach using the following directions. Accessories will not stay on. Not properly installed. Check for proper assembly. Review this guide for assembly instructions. Please refer to your local telephone directory for your nearest Electrolux Service Agent. [. . . ]