User manual AEG-ELECTROLUX Z382A

[. . . ] Enviro Multi Steamer Plus Household Type Steam Cleaner Owner's Guide Z382 Series IMPORTANT For service, spares or any advice in the UK, please contact Electrolux Customer Care on 08706 055 055. For service, spares or any advice in other locations, please refer to your local telephone directory for your nearest Electrolux Service Agent. INDEX Important Safeguards . . . . . . . . . . . . . . . . . . . 2 Service Information . . . . . . . . . . . . . . . . . . . . . . 4 Use & Assembly . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The fabric tool may be used to steam wrinkles out of clothing, curtains, etc. CAUTION: Do not direct steam at the body The Enviro Multi Steamer Plus is equipped with a high performance steam iron. The high quantity of steam generated by the boiler assists in reducing the amount of time spent ironing and the temperature can be regulated to suit all types of fabrics. Ironing is faster and easier, even with the driest and toughest of fabrics. Other Advantages of the Electrolux Enviro Multi Steamer Plus The Electrolux Enviro Multi Steamer Plus steam cleaner can kill dust mites and some types of bacteria, such as salmonella and E-coli when used as directed. To disinfect a specific area, position the steam cleaner over the area, not more than 2. 5 cm away and slowly move across the surface. This allows the surface under the steam cleaner to reach approximately 77°C . Use this procedure to disinfect surfaces in: the bathroom, kitchen, pillows and bedding, pet sleeping quarters, etc. 4 Description of the Electrolux Multi Steamer Plus 1. Handle Safety cap Steam regulation knob Cable winder cavity Power supply cable Amber indicator light (steam ready) Green indicator light (power on) ON/OFF switch Appliance body Steam gauge Extension tubes Floor cloth Floor brush Elbow Glass cleaner connector Round brush (1 brass, 1 plastic) Angled nozzle 18. Iron rest 24 23 20 25 21 22 19 26 17 18 16 11 3 1 2 4 5 32 31 30 29 15 10 7 8 6 33 9 13 14 12 28 27 5 INSTRUCTIONS FOR USE: Filling the boiler tank before use Before unscrewing the tank cap, always ensure that the cleaner is switched off and disconnected from the power supply. Unscrew safety cap (2) and, using funnel (28), POUR INTO THE TANK TWO MEASURES (27) OF WATER TO THE LEVEL OF 500cc (FIG. Turning on the appliance To turn on the appliance, insert the power cord plug into an electrical socket and press ON/OFF switch (8); green indicator (7) and amber indicator (6) will come on. As soon as amber indicator (3) goes out, the appliance is ready for use. To prevent steam from being accidentally supplied, move the safety slider (23) to the ·· position. When using the steam cleaner for the first time and to prevent water forming inside the tube, keep the gun higher than cleaner body (9). In any case, both when first using the cleaner and every time it is left unused for a few minutes, press steam supply button (24) and discharge any water that has formed in hose (26) into a container. Then, as soon as the cleaner begins supplying steam only, direct the steam jet towards the floor and press steam supply button (22) at least two or three times. The Enviro Multi Steamer Plus is equipped with a steam regulation knob (3) which allows the quantity of steam to be adjusted. Reduce the steam pressure by rotating the knob to the right for cleaning textiles or delicate surfaces. Turn it to the left for full power when cleaning stubborn grease, grime or fat from hard surfaces Fitting accessories Detachable flexible tube: Insert the plug end of the flexible tube (26) into the socket of the appliance body (9), taking care that the arrow is to the top, as shown in figure H. Extension spout: Insert the extension spout (21) by pushing it into the fixed section of the gun and aligning the groove in the spout with the line on the gun. Align the spout groove with the line on the gun, then rotate the spout 90 degrees (clockwise) in the direction of the arrow until it locks into place (fig. Round brush and angled nozzle: Both accessories can be fitted to the extension spout (fig. [. . . ] Or, leave the floor brush (13) and extension tubes (11) attached to the flexible tube (26) and store it like this by inserting the hook located on the back of the brush (13) in the hole provided behind the cable winder cavity, as shown in figure (L). Rewind the power cable and plug (5) into the into the cable winder cavity (fig. M). IF YOU HAVE ANY FAULTS, QUESTIONS OR PROBLEMS, PLEASE CONTACT: ELECTROLUX CUSTOMER CARE TEL. 08706 055 055 FAX 01582 588380 E-MAIL: electrolux. floorcare@electrolux. co. uk 8 PROBLEM SOLVING NOTE: Unplug the electrical cord before servicing. PROBLEM Appliance won't start. CAUSE SOLUTION Push plug securely into outlet. [. . . ]