User manual AEG-ELECTROLUX Z433

[. . . ] The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels. the flaming of foods beneath the hood itself is severely prohibited. [. . . ] Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The cooker hood is fitted with a sensor which, in the event of extreme variations in temperature, switches the appliance on automatically until the temperature of the environment surrounding the hood has been significantly reduced. The control switches are located on the unit's front panel: 1 Motor ON/OFF button By pressing the button, the hood starts at speed 1. Pressing the button (OFF) while the hood is in function turns the latter off. Increase 2 Speed increase button By pressing the button, the hood starts at speed 1. Pressing the button (while the hood is on) modifies the motor speed: Speed 1: the number "1" appears on the display 1 Speed 2: the number "2" appears on the display 2 Speed 3: the number "3" appears on the display 3 High-speed: the number "4" appears (flashing) on the display The high-speed function is regulated by a timer. The standard time setting is 5', at the end of which the hood adjusts to speed 2. Press button 2 to deactivate this function before the set time expires; the hood will adjust to speed 1. Speed timer button 4 Press button "4" to activate the speed timer; the hood turns off once the set time expires. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. The charcoal filter should only be used if you want to use the hood in recirculation mode. To do this you will need an original charcoal filter (available from your local Service Force Centre). The charcoal filter cannot be washed nor regenerated. The charcoal filter should be replaced every 4 months under normal use. Replacement filters are available from your local Service Force Centre. Fitting Position the carbon filter inside the hood to cover the protection grill of the motor. Always specify the hood model number, serial number and product number code when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. [. . . ] If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions. Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. Do not connect the appliance to the mains until the installation is fully complete. [. . . ]