User manual AEG-ELECTROLUX Z4386

[. . . ] 5-6 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Dust Cup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Brush Roll . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux Retailers and must be of the same colour as indicated by the coloured insert on the base of the plug. If difficulty is experienced in obtaining a replacement, contact Electrolux on 08706 055055. In no circumstances must the plug be used without a correct fuse cover fitted. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home. The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. Make certain that your cleaner does not come into contact with water or any other liquid. It is not designed as a wet pick up cleaner, and must never be used on damp carpets or wet floors. · · · · Important ­ in the event of the mains supply cable of this vacuum cleaner requiring replacement, we recommend that this be carried out by a Electrolux Service Agent. Spares New filters can be obtained from Authorised Electrolux Dealers and electrical retailers. If difficulty is experienced in obtaining spares please call us on 08706 055055. DO NOT OIL the motor at any time. The bearings are permanently lubricated and sealed. Rating Plate The model, type, and serial numbers are indicated on the rating plate located on the back side of the cleaner. For prompt and complete service information, always refer to these numbers when inquiring about service. MODEL VOLTS TYPE WATTS ELECTROLUX SERIAL NO. ________________________ 4 HOW TO ASSEMBLE b To assemble the cleaner, find the powerhead (a) and the body (b). Align the connector on the powerhead with the receptacle on the body and press together until they click into place. a HOW TO USE 1 3 Position ON/OFF Switch 2 Locked Brush Roll Indicator 1 Power Switch Top position is Off. Middle position is for floor cleaning and cleaning with accessories (brush roll does not turn). Bottom position is for cleaning carpets (brush roll turns). 2 Locked Brush Roll Indicator The brush roll indicator will illuminate brightly when the brush roll motor has been locked up due to debris or some other excessive loading of the brush roll. Slide the power switch to the off position and check the brush roll area for obstructions. [. . . ] Remove the dust cup by pressing down on the dust cup latch (a) and pulling dust cup away from cleaner body. When replacing the dust cup put bottom of dust cup in place by aligning tabs in slots and pivot dust cup up against the cleaner body. Lift up on dust cup latch to secure in place. Check and clean the Pleated Filter once a month to maintain good performance. [. . . ]