User manual AEG-ELECTROLUX Z4410

[. . . ] Never vacuum: · Sharp objects · Fluids (this can cause serious damage to the machine) · Hot or cold cinders, lit cigarette butts, etc. · Fine dust from plaster, concrete, flour or ash, for example. The above can cause serious damage to the motor - damage which is not covered by the warranty. Electrical cable precautions: · A damaged cable must be replaced by an authorised Electrolux service engineer. [. . . ] 4 Open the filter grill to remove the exhaust filter. 5 Take the filter with grill out of its place (a) and remove the filter (b). 4 5a 5b 1 2 3 2 Rinse the filter under tap water and dry it completely. 5a Put the filter with grill back to the cleaner and close the grill (7). Note: Do not use cleaning agents and avoid touching the delicate filter surface. 6 CLEANING THE HOSE AND NOZZLE The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked, or the filter and dustbag are blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters or the full dustbag. Tubes and hose 1 Use a cleaning strip or similiar to clear the tubes and hose. 2 It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. Cleaning the floor nozzle 3 To avoid reduction in suction power, frequently clean the dual purpose floor nozzle. The easiest way to clean it is by using the hose handle. 2 1 3 7 TROUBLESHOOTING AND CUSTOMER INFORMATION Troubleshooting The vacuum cleaner does not start 1 Check that the cable is connected to the mains. 2 Check that the plug and the cable are not damaged. The vacuum cleaner stops 1 Check whether the dustbag is full. Water has entered the vacuum cleaner It will be necessary to replace the motor by an authorised Electrolux service engineer. Damage to the motor caused by the penetration of water is not covered by the warranty. Customer Information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. This product is designed with the environment in mind. All plastic parts are marked for recycling purposes. For further details see our website: http://www. electrolux. co. uk/ For repairs or accessories, contact the Electrolux Group Floorcare Helpline on 08706 055 055. If you have any comments on the cleaner or the Instructions for Use booklet please contact us on 08706 055 055. 8 ELECTRICAL SUPPLY INSTRUCTIONS Before you start . . . check the voltage Before connecting the cleaner to an electrical supply ensure that voltage marked on the data plate (on the underside of cleaner) is correct for your electrical supply. If is not, do not use the cleaner but refer back to your dealer. [. . . ] · Do not put any object into openings. Do not use with any opening block, keep free of dust, lint, hair and anything that may reduce air flow. · Do not use to pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. · Do not use without dust bag in place. [. . . ]