User manual AEG-ELECTROLUX Z4520T

[. . . ] The above can cause serious damage to the motor - damage which is not covered by the warranty. Electrical cable precautions: · A damaged cable must be replaced by an authorised Electrolux service engineer. Damage to the cleaner cable will not be covered by the warranty. · Never pull or lift the vacuum cleaner by the cable. [. . . ] 6 Close the cover by pressing down until it clicks. 8 9 9 10 11 4 5 Cleaning the motor filter (The motor filter should be cleaned approximately every three months, or when required for more frequent use). 1 2 3 1 2 3 CLEANING THE HOSE AND NOZZLE Pull dustbag upward and remove the motor protection filter. Rinse the filter under tap water and allow 24 hours to dry. Put the filter back into the cleaner and close the cover. Filter reference number: EF 1. 1 The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked, or the filter and dustbag are blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters or the full dustbag. Check the blockage in the hose by dropping a small coin through it. Tubes and hose 1 Use a cleaning strip or similiar to clear the tubes and hose. 2 It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. Cleaning the floor nozzle 3 To avoid reduction in suction power, frequently clean the dual purpose floor nozzle. The easiest way to clean it is by using the hose handle. Replacing the micro exhaust filter (The exhaust filter should be replaced approximately every 4 months). 4 5 6 5 6 4 5 6 Open the filter grill to remove the exhaust filter. Take the filter out of the grill and insert a new one. Put the filter set back into the cleaner. Close the filter cover. 2 Note: Do not use cleaning agents and avoid touching the delicate filter surface. 3 6 7 TROUBLESHOOTING AND CUSTOMER INFORMATION ELECTRICAL SUPPLY INSTRUCTIONS Before you start . . . check the voltage Before connecting the cleaner to an electrical supply ensure that voltage marked on the data plate (on the underside of cleaner) is correct for your electrical supply. If is not, do not use the cleaner but refer back to your dealer. Connecting to your electrical supply Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse and the fuse cover mustbe replaced before the plus is used again. [. . . ] The guarantee may be invalidated by unauthorised repair or modification of the appliance. You may be charged by the Electrolux Group if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet. The Company does not accept liability for defects arising from neglect, misuse or accident. This guarantee excludes such normal wearing parts as filters, brushes and dust bags as the life of these depends upon the amount and nature of use. [. . . ]