User manual AEG-ELECTROLUX Z4541

[. . . ] The vacuum cleaner features double insulation and does not need to be earthed. Never vacuum: · In wet areas · Close to flammable gas, etc. · Without a dustbag (this may damage the cleaner). A safety device is fitted which prevents the cover closing without a dustbag in place. [. . . ] 8 Replace the plastic clip ensuring that both sides of the bag are parallel. Note: The bag may be washed in luke warm water Allow to dry it for 24 hours. It should not be washed in washing machine (10). 6 Close the cover by pressing down until it clicks. 8 9 9 10 11 4 5 Cleaning the motor filter (The motor filter should be cleaned approximately every three months, or when required for more frequent use). 1 2 3 1 2 3 CLEANING THE HOSE AND NOZZLE Pull dustbag upward and remove the motor protection filter. Rinse the filter under tap water and allow 24 hours to dry. Put the filter back into the cleaner and close the cover. Filter reference number: EF 1. 1 The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked, or the filter and dustbag are blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters or the full dustbag. Check the blockage in the hose by dropping a small coin through it. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. [This cleaner is double insulated and no earth-connection is necessary. ] It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of guarantee. As a general guide to fitting any plug · Ensure the lengths of wire inside the plug are prepared correctly. · Connection should be firmly made after all conductor stands are entered into the terminal posts. · When preparing the cable ends take care not to damage the outer seal, or insulation surrounding the inner conductors. · Replace the top cover of the plug and secure. Troubleshooting The vacuum cleaner does not start 1 Check that the cable is connected to the mains. 2 Check that the plug and the cable are not damaged. The vacuum cleaner stops 1 Check whether the dustbag is full. Water has entered the vacuum cleaner It will be necessary to replace the motor by an authorised Electrolux service engineer. Damage to the motor caused by the penetration of water is not covered by the warranty. [. . . ] You may be charged by the Electrolux Group if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet. The Company does not accept liability for defects arising from neglect, misuse or accident. This guarantee excludes such normal wearing parts as filters, brushes and dust bags as the life of these depends upon the amount and nature of use. Proof of the date of purchase will be required before service under guarantee is provided. [. . . ]