User manual AEG-ELECTROLUX Z4623

[. . . ] 5-6 Thermal Cut Off . . . . . . . . . . . . . . . . . . . . . 3 & 7 Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Dirt Alert . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Important: For future reference we suggest you record the following details here, and keep the receipt with the handbook as proof of purchase. Purchased from ______________________________________________ Date purchased _______________Model no _______________________ LUTON, BEDFORDSHIRE, LU4 9RJ Features of the Electrolux vacuum cleaner and accessories supplied with it are protected in Great Britain and abroad by Patents or Registered Designs. This appliance conforms with the requirements of the amended E. E. C. 89/336/EEC relating to electromagnetic compatibility (EMC) CE. Electrolux, may introduce modifications to their product from time to time, and consequently the details given in this booklet are subject to alteration without notice. 4 HOW TO ASSEMBLE CAUTION: Assemble the cleaner before using. NOTE: Features may vary by model yet all parts assemble the same. Step A Attach Handle CAUTION: Do not catch cord under handle. Step B Attach Hose 3 Button Hole 1 Groove Groove 2 Hose Hose Retainer 4 1. From rear of cleaner, align handle with groove and slide onto cleaner. If necessary, use thumb and finger pressure to slide handle into position. Attach handle with two 1 inch screws in the assembly packet. Use either a slotted or Phillips ® head screwdriver. NOTE: Hand tighten with screwdriver to be sure both screws are firmly seated. 3. If there is no break in the light beam, the floor is clean and no light will come on. When using your new vacuum you may be cleaning deep down hidden dirt missed by your old vacuum causing the light to stay red longer. With frequent cleaning, after the first few times you use your new Electrolux vacuum, the red light should go on less. NOTE: The dirt alert feature is not intended to be used for above the floor cleaning with attachments. The red light indicates dirt, dust, etc. is still being removed from the area being cleaned. How to Check the Dirt Alert Sensors To check if dirt sensor is working properly. While the red light is on, tip the vacuum backwards on rear wheels, lifting the brush roll off the carpet a couple of inches. After a few seconds the red light should turn off. HINT: New carpeting has loose carpet fibers which will trip the red light sensor beam. Hose Infrared emitter and sensor Hose Retainer 9 HOW TO MAINTAIN The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the cyclonic dust cup, belt, and brush roll often. To Change Dust Cup Pleated Filter: NOTE: Turn off the switch and unplug the electrical cord before changing the pleated filter. Never operate the vacuum cleaner without the dust cup or the pleated filter assembly. [. . . ] Call Electrolux on 80706 055055 for assistance. 16 STAIR CLEANING HOSE (Only on Certain Models) WARNING: Never position any cleaner on the stairs as this could damage the carpet. Some models will come complete with an extra bonus hose which is ideal for cleaning stairs. HOW TO ASSEMBLE AND USE WARNING Step 1 - Remove the hose attached to the cleaner. Always work with the cleaner below you, pulling hose from side of cleaner; not the back or the front of the cleaner. Ensure it is positioned sideways up against the bottom step. Step 2 - Connect the hose cuff to the end of the bonus hose. [. . . ]