User manual AEG-ELECTROLUX Z47

[. . . ] Use only manufacturer's recommended attachments. · Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre before using. capabilities, or a lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. · Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run vacuum cleaner over cord. · Do not use extension cords or outlets with inadequate current carrying capacity. [. . . ] 89/336/EEC relating to electromagnetic compatibility (EMC) CE. Electrolux may introduce modifications to their product from time to time, and consequently the details given in this booklet are subject to alteration without notice. Quick Reference QUICK REFERENCE A B C E F G G1 A B C D E F G H I J K Wand Crevice Tool Dusting Brush Hose Base Dust Cup with Lid and Filter Handle ( G1 Turbo Handle) Tool Caddy Rear Housing Hose Retainer Stair Brush J D K H Stair Brush (some models only) I How To Assemble HOW TO ASSEMBLE CAUTION: Assemble the cleaner completely before using. NOTE: All screws must be installed to properly secure the parts of the vacuum. CAUTION: Moving parts, make sure the on/off switch is in the off position and stay clear of the brushroll when plugging in. NOTE: Features may vary by model yet all parts assemble the same. Remove all components from the carton and check that all of the parts are available from the parts list above. Have a Phillips screwdriver available (one is NOT provided in the package). (NOT provided in the package) L1 l L2 l 5 How To Assemble (continued) I E Step 1: Assemble the rear housing l to the base l by sliding it on top of the base and attaching to the base L2 using a long screw provided l. Unwrap the cord by turning the quick release cord hook (FIG. 10a), unwind the cord and plug into an appropriate outlet. To use, push electrical cord down into cord retainer (FIG. CAUTION: Do not place the cleaner on stairs or on a stair above you when cleaning stairs. 14 Use Handle Release Step on handle release (FIG. 14a) and pull handle back to a comfortable position. Press again to lower handle further to clean under furniture. Return to full upright position to use the hose and attachments. 14) HELPFUL HINT: Before cleaning under low furniture, check area first for objects that might harm the unit or block the vacuum hose. 14a HOW TO USE How To Use Accessories CAUTION: Do not place the cleaner on furniture or steps for any period of time as the brush roll may cause damage. Place the cleaner on the floor with the handle in the upright/storage position while using the accessories. Remove hose from hose adapter on the base of cleaner. Place desired accessory onto end of hose or wand. A Nested Extension Wand l to add reach. 15) B Crevice Tool l cleans corners, baseboards and between cushions. C Dusting/Upholstery Brush l is for furniture, blinds, books, lampshades, shelves, curtains, draperies, cushions and fabrics. FIG. [. . . ] Step 4: If a full dust cup, clogged hose or clogged filters are found, empty the dust cup, unclog the hose or replace the filters. Step 5: Wait at least 30 minutes before attempting to reuse the cleaner. Step 6: After a 30-minute cool down period, plug the cleaner in and push the switch pedal. Step 7: If the cleaner still does not operate, please call Electrolux Customer Care on 08445 614614. [. . . ]