User manual AEG-ELECTROLUX Z5045

[. . . ] The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. When used as an extractor unit, the hood must be fitted with a hose having preferably the same diameter as the outlet hole. Attention: The hose is not supplied and must be purchased separately. The hood must NEVER be used as a support surface unless specifically indicated. [. . . ] Correct ventilation: If the cooker hood is to work correctly there must be an Correct under pressure in the kitchen. It is important to keep the kitchen windows closed and have a window in an adjacent room open. press to switch the suction motor on and off. Turn the handle clockwise to increase the suction power and anti-clockwise to diminish it. (normally deactivated - activate with the correct procedure) This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Set in "OFF the hood. oFF" OFF Press buttons 1 and 2 simultaneously and hold them for 3 seconds. At first only the grease filter LED 3 will light up, but when the charcoal filter LED 4 lights up the saturation indicator will be enabled. To disable it: Press buttons 1 and 2 again simultaneously and hold them for 3 seconds, until the charcoal filter LED 4 goes out. Grease Grease filter LED LED 3 will start to flash when it is time to clean the grease filter. Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the charcoal, the filter should be dried in an oven for 10 minutes with a maximum temperature of 100º C. After approximately three years of use, the charcoal filter should be replaced with a new, as the odour reduction capacity will be reduced. Fitting Remove the frame i which supports the filter h by turning 90° the two knobs g. Insert the charcoal filter inside the frame and put all parts back in their place. Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. The charcoal filter can be ordered from your local Service Force Centre. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Prior to touching the light bulbs ensure are ensure they are cooled down. [. . . ] Turn off the hob and then wait for the device to reset. If the hood has been installed below the heights indicated in the installation instructions the motor will cut-out frequently which will damage the hood. If after all these checks, the problem persists, contact your local Service Centre, quoting the model and serial number. Please note that it will be necessary to provide proof of purchase for any inguarantee service calls. [. . . ]