User manual AEG-ELECTROLUX Z5305 GB

[. . . ] In the event of the fuse requiting replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. [. . . ] · Repairs to electrical appliances must be carried out by qualified service engineers. Improperly performed repairs can result in considerable danger for the user. · If the power cable is defective the entire cable roller must be exchanged by the AEG customer service or an authorised workshop. · The manufacturer accepts no liability for any damage caused by improper use or incorrect operation. In the event of a fault please contact your specialist dealer or the Electrolux customer service directly. This vacuum cleaner complies with the following EU Directives · 73/23/EEC of 19. 02. 1973 ­ Low Voltage Directive. · 89/336/EEC of 03. 05. 1989 (including revised Directive 92/31/EEC) ­ EMC Directive. 4 Exploded view and assembly Cable rewind foot switch Foot switch ON/OFF "Empty dust collector" indicator Opener for dust-collector compartment E Suction hose * depending on model A B C D F G H J K Accessories holder * Suction control * Metal tubes (2) * Floor nozzle * Power cable F* E G* A B C D H* K J* 5 Vacuum cleaning · Withdraw cable, insert mains plug. (To roll the cable up press foot switch A. Please hold the plug. ) · Switch on/off with foot switch B (on the lowest power setting, there may be a start delay up to 4 seconds due to the electronic starting current limiter *). · Suction capacity can be reduced by opening the suction control G *. If you open the suction control G on the bent end, you can reduce the force required to push the nozzle across the carpet, and enable you to clean lightweight rugs, curtains and upholstery. * depending on model G* A B 6 Nozzles L M N O Floor nozzle *, dual purpose for carpets and hard floors Furniture brush * Crevice nozzle * Upholstery nozzle * (threads and fluff are effectively removed) * depending on model L* * M* N* O* 7 Emptying dust collector/cleaning filters · We recommend emptying the dust collector after each use, but no later than when indicator C shows red all over (with the unit switched to maximum suction capacity and the nozzle raised from the floor). If necessary, also brush dust from the collector filter. Caution: open dust-collector compartment cover fully until it locks in place!If the collector is cleaned wet (see also p. 10): allow to dry well before refitting. · If the suction power falls off noticeably even after the dust collector has been emptied (or if indicator C is red), rinse out all filters under hot running water. Replace filters if necessary. * depending on model 1 C 2 3 * 4 5 6 8 Transport and storage P 9 Maintenance and cleaning Before starting maintenance or cleaning, switch off the unit and withdraw the mains plug. Wipe over unit and dust-collector compartment if necessary with a damp cloth and allow to dry. Do not use abrasive materials or solvents. [. . . ] The guarantee may be invalidated by unauthorised repair or modification of the appliance. You may be charged by Electrolux if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet (example: blocked/dirty filters). The Company does not accept liability for defects arising from neglect, misuse or accident. [. . . ]