User manual AEG-ELECTROLUX Z5311

[. . . ] As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. [. . . ] · Repairs to electrical appliances must be carried out by qualified service engineers. Improperly performed repairs can result in considerable danger for the user. · If the power cable is defective the entire cable roller must be exchanged by the AEG customer service or an authorised workshop. · The manufacturer accepts no liability for any damage caused by improper use or incorrect operation. In the event of a fault please contact your specialist dealer or the Electrolux customer service directly. This vacuum cleaner complies with the following EU Directives · 73/23/EEC of 19. 02. 1973 ­ Low Voltage Directive. · 89/336/EEC of 03. 05. 1989 (including revised Directive 92/31/EEC) ­ EMC Directive. 4 English Exploded view and assembly A Cable rewind foot switch B Foot switch ON/OFF C Empty dust collector/Clean filter indicator D Opener for dust-collector E Suction hose F Tool storage * G Suction control * H Metal tubes (2)* / Telescopic tube* J Floor nozzle * compartment K Power cable * depending on model Vacuum cleaning · Withdraw cable, insert mains plug. (To roll the cable up press foot switch A. Please hold the plug. ) · Switch on/off with foot switch B (on the lowest power setting, there may be a start delay up to 4 seconds due to the electronic starting current limiter *). · Suction capacity can be reduced by opening the suction control G *. If you open the suction control G on the bent end, you can reduce the force required to push the nozzle across the carpet, and enable you to clean lightweight rugs, curtains and upholstery. * depending on model 6 English Nozzles L Floor nozzle *, dual purpose for carpets and hard floors M Furniture brush * N Upholstery nozzle* (threads and fluff are effetively removed) O Crevice nozzle * depending on model Emptying dust collector/ cleaning filters · We recommend emptying the dust collector after each use, but no later than when indicator C shows red all over (with the unit switched to maximum suction capacity and the nozzle raised from the floor). If necessary, also brush dust from the collector filter. Caution: open dust-collector compartment cover fully until it locks in place!After washing the dust collector, please allow to dry thoroughly before refitting. · If the suction power falls off noticeably even after the dust collector has been emptied (or if indicator C is red), rinse out all filters under hot running water. * depending on model 8 English Transport and storage Maintenance and cleaning Before starting maintenance or cleaning, switch off the unit and withdraw the mains plug. Wipe over unit and dust-collector compartment if necessary with a damp cloth and allow to dry. Do not use abrasive materials or solvents. [. . . ] The guarantee may be invalidated by unauthorised repair or modification of the appliance. You may be charged by Electrolux if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet (example: blocked/dirty filters). The Company does not accept liability for defects arising from neglect, misuse or accident. [. . . ]