User manual AEG-ELECTROLUX Z5510

[. . . ] Upright Vacuum Cleaner Owners Guide Household Type 2- 4 4 5- 6 7- 8 8 9 10 10 11 - 12 12 - 13 14 IMPORTANT INFORMATION GUARANTEE HOW TO ASSEMBLE HOW TO USE Thermal Cut Off Accessories Z5500 Series ROUTINE MAINTENANCE Hose Blockage Brush Roll Brush Roll Belt Dust Cup Dust Cup Filter PERIODIC MAINTENANCE Filters Problem Solving For any advice on your cleaner and to order filters and accessories, please telephone the Electrolux Helpline on IMPORTANT 14 15 08706 055055 www. electrolux. co. uk When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. IMPORTANT SAFEGUARDS WARNING To reduce the risk of fire, electric shock, or injury: · Do not use outdoors or on wet surfaces. · Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. · Do not allow to be used as a toy. Close attention is necessary when used by or near children. [. . . ] Find the two screws in the accessory bag included in the carton. Pull handle back to a comfortable position. Press release again to lower handle further to clean under furniture. To check condition of belt watch to see if white dots on belt are moving through the window. This indicates the brush roll is turning. Remove these screws to release hood and give access to brush roll belt area. The base of the cleaner has an adjustment that raises or lowers the cleaning head to match the type of floor surface. With the cleaner cord unplugged, the height adjustment knob should be rotated to the desired position. For ease in moving the adjustment knob, place the handle in the upright parked position and tilt the cleaner back to remove weight from the front wheels. If you have long pile carpet, set the knob to the highest setting marked Long Pile. For short pile carpets set the knob to the lowest setting which is marked Short Pile. If the cleaner is difficult to push, rotate the adjustment knob to the next highest setting until the cleaner is comfortable to push. The brush roll must reach the carpet for effective cleaning. For use on hard floors, care must be taken to avoid damage to the flooring caused by repeated contact from the brush roll. Therefore, do not set on the Short Pile setting, but in the mid point setting between Short Pile and Long Pile. For above the floor cleaning using the tools supplied, turn to the Tools setting. The cleaner should be in the upright parked position to avoid repeated contact of the brush roll with the floor surface. Keep loose clothing, hair, fingers, and all other parts of body away 9 from any moving part (such as the revolving brush). Turn off the switch and unplug the cleaner before changing the cleaner height setting. Use these wands on the end of the hose for added cleaning reach. 7 How To Use (continued) 12. Place hose on retainers to store hose on unit. Use this handle to carry unit from one place to another. [. . . ] Make sure bag cover is installed properly. Replace a cut, loose or out of shape belt. Clean hair and thread from bristles and end cap area. Replace brush roll if bristles are worn. [. . . ]