User manual AEG-ELECTROLUX Z5528 F-L EURO

[. . . ] To change position, push the catch on the smaller tube B and turn smaller tube B through a half circle until the catch clicks to engage. Now simply turn the rotary head of the nozzle through a half circle. Use the tubes in this position for cleaning under low furniture. [. . . ] C) Insert new dust bag by sliding the bag slots into the holder. We recommend the dust bag is changed: * after using a carpet cleaning powder * if there is a bad smell from the cleaner, then you should also change/clean the filter Note: Use only Electrolux original dust bags (ref. EF25a) Dust bag safety device To avoid damaging the cleaner, do not use it without a dust bag. A safety device is fitted which prevents the cover closing without a dust bag. Changing/Cleaning the filters Never use the cleaner without the filters in place. The Motor Protection filter should be changed twice a year for normal usage. F) Important: Insert new filter with original covering strip securely in place. The Micro filter 5510/15/20/25/28 should be changed every fifth dust bag. The HEPA filter should be cleaned when the indicator light is on 5530/33/35/36/40 or every fifth dust bag 5522. To clean the HEPA filter: I) Open the filter cover and remove filter unit. J) Rinse the inside (dirty side) of the filter unit under warm tap water only. Repeat cleaning procedure four times and allow the filter to air dry. the original filtering performance is now restored. Replace the unit back into the cleaner and close cover ensuring it is properly fastened. Power: If the electric power does not come on, disconnect from mains and check plugs, cable and fuses where appropriate. Blockage/dirty filters: The cleaner may switch itself off in event of severe blockage or excessively dirty filters (on 5530/33/35/36/40 overheat indicator will flash). [. . . ] it is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee. as a general guide to fitting any plug · Ensure the lengths of wire inside the plug are prepared correctly. [. . . ]