User manual AEG-ELECTROLUX Z5550

[. . . ] If damaged the cable should be replaced at an Electrolux Service Centre The plug must be removed from the socket-outlet before cleaning or maintaining the appliance All service and repairs must be carried out by authorised Electrolux service staff M N O P 3 l m 4 g KTool w i 5 k Getting the best results Using Carpet/Hard floor nozzle v u 45 Carpets: Use floor nozzle with lever in this position. Hard floors: Use floor nozzle with lever in this position. Using Turbo nozzle 5540 or Power nozzle 5560 6 Getting started · Check dust bag is in place. [. . . ] 5510/20/25 the dust bag indicator window will turn red when filling and completely red when full. 5530/35/40/50/60 the dust bag indicator window will light up when full. If the dust bag should accidentally get broken in the cleaner, take cleaner to Electrolux Service Centre for cleaning. To check the dust bag, the cleaner must be switched on, with all attachments connected and off the floor. The dust bag full indicator may signify that the bag is blocked (occasionally caused by very fine dust) which will cause loss of suction and may result in overheating. If this occurs change the dust bag even if it is not full. To change the dust bag: A) Open the cleaner cover. B) Pull the sliding tab to remove the dust bag. C) Insert new dust bag by sliding the bag slots into the holder. We recommend the dust bag is changed: * After using a carpet cleaning powder. * If there is a bad smell from the cleaner, then you should also change the filter. Note: Use only Electrolux original dust bags and filters: Micro filter (ref. EF 25) Dust bag safety device To avoid damaging the cleaner, do not use it without a dust bag. A safety device is fitted which prevents the cover closing without a dust bag. Changing the filters Never use the cleaner without the filters in place. The Motor Protection filter should be changed twice a year for normal usage. [. . . ] when vacuum cleaning carpets or other soft materials. When the nozzle is lifted, the valve is reset. If the safety valve triggers repeatedly during normal use, check and remedy any blockage in the hose, tube, nozzle or filters. [. . . ]