User manual AEG-ELECTROLUX Z5749

[. . . ] Use only manufacturer's recommended attachments. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre before using. · Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Keep cord away from heated surfaces. · Do not use extension cords or outlets with inadequate current carrying capacity. · Turn off all controls before unplugging. [. . . ] Keep loose clothing, hair, fingers, and all other parts of body away from any moving part (such as the revolving brush). Turn off the switch and unplug the cleaner before changing the cleaner height setting. WARNING: Keep children away from rotating parts on cleaner. 9 5 10 Hose Retainers (4) - Place hose in retainers to store hose on unit. 11 Electrical Cord Hooks (2) - Wrap electrical cord around them to store electrical cord on unit. The upper cord hook rotates for quick cord release. 12 Nested Wand Storage - The crevice wand stores inside the larger wand. 10 13 Carrying Handle - Use this handle to carry unit from one place to another. 14 Dusting/Upholstery Brush Storage - Store the dusting brush on back of cleaner. 11 13 10 12 NOTE: WHEN UNIT IS RUNNING, DO NOT ATTEMPT TO REMOVE ANY OBJECT WHICH PREVENTS THE BRUSH ROLL FROM TURNING. First, turn off unit, unplug from the electrical socket, then remove object from brush roll area. Eg: sock, rug, etc. QUICK REFERENCE 6 Thermal Cut Off 10 14 11 10 This cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly turns off, follow this procedure: 1. An adjustment hair, fingers, and all other parts of that raises or lowers the cleaner base body away from any moving part to match the type of floor surface. Never operate the vacuum cleaner without the dust bag or filter assembly in place. ROUTINE MAINTENANCE Removing the Dust Bag Code E84: 1 Remove dust bag cover by lifting up on latch and pivoting dust bag cover out and away from cleaner. 2 Grasp dust bag flaps and pull out from cleaner. Latch Flaps Dust Bag Installing New Dust Bag: BEND FLAPS FORWARD Reinstalling the Dust Bag Cover: Place the bottom of the dust bag cover on cleaner lining up grooves on outer edge of cover with rails on side of cleaner. Rotate cover up, pressing against cleaner until it locks into place. PLACE BAG FLANGE ON TOP OF SHELF PUSH BAG INTO HOUSING POSITION BAG BOTTOM BEHIND RIBS 10 Rails on Cleaner Grooves on inside edge of bag cover Pre-Motor Filter Check the pre-motor filter each time the dust bag is changed. Dust Bag Support To Clean Pre-Motor Filter 1. Locate dust bag support in bottom of dust bag compartment. Remove filter centered in the bottom of the dust bag compartment. If necessary, the filter can be cleaned by vacuuming with another cleaner or washing with mild detergent. Reinstall filter after completely dry. ROUTINE MAINTENANCE Pre-Motor Filter Side Door Filters Models equipped with Filter Pad Wash the filter pad frequently to maintain best performance; at least once every month. Replace as needed. To remove Filter Pad from filter door 1. Push down on filter door latch and pull door away from cleaner. [. . . ] Replace a broken, cut, loose or out of shape belt. Tilt the cleaner back to raise the front wheels off floor. Replace a broken, cut, loose or out of shape belt. Tilt the cleaner back to raise the front wheels off floor. [. . . ]