User manual AEG-ELECTROLUX Z5810 T

[. . . ] · Attach telescopic tube 5510 or back saver tube 5520/25/30/35/40/50/60 to hose handle. · Use back saver tube 5520/25/30/35/40/50/60 in positions shown for normal cleaning or cleaning under low furniture. To adjust, press catch and twist lower tube. Precautions: Only use nozzle on carpets with a pile depth under 15 mm. Do not use on animal skins or rugs with long fringes. [. . . ] To avoid damaging your carpet, do not keep nozzle stationary whilst brush is rotating. Do not pass nozzle over mains cable and switch off nozzle immediately after use. · Attach turbo nozzle 5540 or power nozzle 5560 to tubes. · Connect power nozzle plug to hose handle socket and use clips to secure cable to tube 5560. · Push on/off switch to activate power nozzle 5560. · Note: Suction can also be regulated on turbo nozzle by opening/closing air vent 5540. 11047 Electrolux VC 12/11/1998 1:08 pm Page 2 Title: Electrolux Perfexio ID: English (GBB) Proof No: 06 Page: 2 The Global Appliance Company Cleaning Turbo nozzle 5540 or Power nozzle 5560 · Disconnect from mains and remove entangled threads from nozzle by snipping threads with scissors. · To clean inside nozzle, open cover by unscrewing 5540 or by releasing catches 5560. · Remove brush cylinder and supports. To clean wheels, gently lever them from their mountings. Replace cover ensuring it is properly fastened. Using combination nozzle/brush 5550/60 · Use in position shown for cleaning upholstery. The Micro filter 5510/20/25 should be changed every fifth dust bag. To change Micro filter: G) Open the filter cover. 2 H) Replace filter and close cover ensuring it is properly fastened. The CleanStream filter should be cleaned when the indicator light is on 5530/35/40/50/60. To clean the CleanStream filter: I) Open the filter cover and remove filter unit. J) Rinse the inside (dirty side) of the filter unit under warm tap water only, keeping the outside dry. Do not use cleaning agents and avoid touching the delicate filter surface. Tap the filter frame to remove excess water. Repeat cleaning procedure four times and allow the filter to air dry. The original filtering performance is now restored. Replace the unit back into the cleaner and close cover ensuring it is properly fastened. Troubleshooting Power: If the electric power does not come on, disconnect from mains and check plugs, cable and fuses where appropriate. The cleaner may switch itself off in event of severe blockage or excessively dirty filters (on 5530/35/40/50/60 overheat indicator will flash). [. . . ] Replace the unit back into the cleaner and close cover ensuring it is properly fastened. Troubleshooting Power: If the electric power does not come on, disconnect from mains and check plugs, cable and fuses where appropriate. The cleaner may switch itself off in event of severe blockage or excessively dirty filters (on 5530/35/40/50/60 overheat indicator will flash). In such cases, disconnect from mains and allow to cool for 30 minutes. Clear blockage and/or replace filter(s) and restart. [. . . ]