User manual AEG-ELECTROLUX Z58A

[. . . ] If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center before using. Do not pull or carry by cord, use cord as a handle, close door on cord, or pull cord around sharp edges or corners. Do not use extension cords or outlets with inadequate current carrying capacity. Turn off all controls before unplugging. [. . . ] If difficulty is experienced in obtaining spares please call us on 08706 055055. Rating Plate The model, type, and serial numbers are indicated on the rating plate located on the back side of the cleaner. For prompt and complete service information, always refer to these numbers when inquiring about service. MODEL VOLTS TYPE WATTS ELECTROLUX SERIAL NO. ________________________ 4 71520 4 9/21/05, 10:09 AM HOW TO USE The lightweight vacuum cleaner is designed to be used for quick, convenient, and easy cleanups. Moving the nozzle over carpeting, rugs, or upholstery provides suction and bristle agitation to clean dirt, lint, and threads from surfaces. The convenient Riser VisorTM nozzle cover rotates upward to clean floors or downward to clean stair risers or furniture backs. Back Power Switch The power switch is located on the top of the handle. Slide the switch forward to turn the motor ON; slide back to turn the motor OFF. Forward Riser VisorTM Nozzle Cover The Riser Visor nozzle features a rotating cover over the brush roll. When the cover is in the normal position, the brush roll action is toward the bottom side of the nozzle to clean flat areas such as stair steps or upholstery. Pull back on the release lever and pull upward to rotate the cover downward and expose the brush roll to the front of the nozzle for cleaning stair risers or furniture backs. Cover Pull Release Lever Caution: To prevent injury, turn off the switch before rotating the Riser Visor nozzle cover. Cord Storage Wind the cord loosely around the vacuum cleaner unit for storage. Fasten the plug to the cord to prevent unwinding. 5 71520 5 9/21/05, 10:09 AM HOW TO MAINTAIN The instructions given in this booklet serve as a guide to routine maintenance. Keep the vacuum cleaner at top operating efficiency. Clean the filter and empty the dust container regularly. If the dust container is visibly full before finished cleaning, empty as needed. Dust Container and Motor Filter Empty the dust container and clean the motor filter regularly to keep the vacuum cleaner operating efficiently. Make sure the filter is securely attached in place before vacuuming. Failure to replace the filter will allow dust to enter the motor section which will damage the vacuum cleaner. Some fine particles can restrict airflow very quickly and will decrease performance even before the dust container appears full. For that reason, when vacuuming carpet fresheners or cleaners, powder, plaster dust, or similar fine substances, the dust container and filter may need cleaning more often. NOTE: Turn off the switch and unplug the electrical cord before emptying the dust container and cleaning the motor filter. Latch Press the dust container latch, located below the electrical cord, and rotate the dust container off the unit. Grasp the motor filter and pull up to remove. Shake dust container contents into a suitable container. If further cleaning is desired, hand launder the washable motor filter in warm water using a mild detergent. Air dry thoroughly before returning it to the dust container. [. . . ] You may be required to take the product to your nearest service provider if the product requires attention during the first year. There are certain conditions which may invalidate this guarantee: a. It is dependent upon the appliance being correctly installed and used in accordance with the Company's instructions under normal domestic conditions within the United Kingdom or the Republic of Ireland. Service at all times must be carried out by an Electrolux Service Representative or authorised agent. [. . . ]