User manual AEG-ELECTROLUX Z6035 PRAXIO

[. . . ] . 22 i Indice f Sommaire Description de l'appareil . 11 Avant la première mise en service . 11 Par respect pour l'environnement. 15 Nettoyage de meubles capitonnés et coussins . [. . . ] When using deodorisers in the dust bag, please observe the manufacturer's instructions exactly. When you have finished cleaning, remove the accessories in the reverse order of fitting. To pull the suction hose (23) out press the button on the end of the hose (J). Dust bag full indicator The indicator on the housing lid (26) will show red when the dust bag (24) is full. Dry vacuuming 1 Important: Once the appliance has been used for wet vacuuming, it must be allowed to dry completely; if necessary the hose and tubes must also be completely dried before use. Open the appliance by pulling the lid catch (7) (A). Insert the dust bag (24) in the guide and push as far as it will go (B). Turn the suction elbow (8) to the "Dry" position (C). Connect the end of the hose to the hose connector (6) (E). The accessories are pushed on to the end of the suction tube (20a/b) (F). · Floor nozzle (19) · Crevice nozzle (17): eg. Pull out the power supply cable (G) and insert the plug into a socket. Using the electronic suction control (3) (Z 6035 only) you can set the required, continuously variable, level of suction power. The suction power can also be regulated at the handle (F/22). Hot ashes, glowing cigarette ends, inflammable or corrosive materials and fine dust must not be vacuumed. 1 0 0 0 0 0 0 Always change the dust bag after cleaning floors that have previously been treated with powder cleaners, as residues will damage the appliance over time. The dust bag has a flap that retains the vacuumed dirt (L). Wet vacuuming 0 Open the appliance by pulling the lid catch (7) (A). 1 0 0 0 0 0 0 0 0 0 0 Check that there is no dust bag in the appliance. Turn the suction elbow (8) to the "Wet" position (S). Only wet vacuum when the appliance is horizontal. Connect the end of the hose to the hose connector (6) (E). Push the handle (21) into the suction tube (20) and lock both pieces into place. Close the suction regulator (22) on the handle. Using the electronic suction control (3) you can set the required, continuously variable, level of suction power (I). After vacuuming liquids the suction tube should be held up for a few seconds with the appliance switched on. This will suck the remaining liquid out of the hose and suction tube. 1 1 7 g When you have finished cleaning, remove the accessories in the reverse order of fitting. [. . . ] · Cleaned surfaces can be dried more quickly by vacuuming again ­ without pressing the spray dispensing button (27) ­ to remove the majority of the remaining liquids. · To clean the spray circulation system and accessories it is necessary to pump approx. 1 l of clean water through the feed tubes before putting the appliance away; This will prevent remnants of the cleaning agent sticking and blocking the appliance and accessories. Proceed as if , , Wet Cleaning Carpets and Upholstery". [. . . ]