User manual AEG-ELECTROLUX Z7108

[. . . ] · Fine dust from plaster, concrete, flour or ash, for example. The above can cause serious damage to the motor - damage which is not covered by the warranty. Electrical cable precautions: · A damaged cable must be replaced by an authorised Electrolux service engineer. Damage to the cleaner cable will not be covered by the warranty. [. . . ] Air dry for approximately 24 hours, to ensure it is completely dry before re-using. Avoid direct sunlight and extreme drying circumstances. If you wish to use your appliance while the cartridge filter is drying, you may use the extra cartridge filter inserted in the packaging box. Insert the cartridge filter into its place (B) and turn it clockwise (A). Insert the filter set back into the dust container. Insert the dust container back into the cleaner by pressing it down until it clicks. Cartridge filter reference number: EF75b Note: Do not use cleaning agents and avoid touching the delicate filter surface. 5 CLEANING THE HOSE AND NOZZLE The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked, or the filters are blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters. Then restart the vacuum cleaner. Use a cleaning strip or similiar to clear the tubes and hose. It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. To avoid reduction in suction power, frequently clean the dual purpose floor nozzle. The easiest way to clean it is by using the hose handle. 1 2 3 6 TROUBLESHOOTING AND CUSTOMER INFORMATION Troubleshooting The vacuum cleaner does not start 1. Check that the cable is connected to the mains. Check that the plug and the cable are not damaged. Check whether the dust container is full. Water has entered the vacuum cleaner It will be necessary to replace the motor by an authorised Electrolux service engineer. Damage to the motor caused by the penetration of water is not covered by the warranty. Customer Information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. This product is designed with the environment in mind. [. . . ] · Do not put any object into openings. Do not use with any opening block, keep free of dust, lint, hair and anything that may reduce air flow. · Do not use to pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. · Do not use without dust container in place. [. . . ]