User manual AEG-ELECTROLUX Z7110

[. . . ] z71xx_ifu. qxp 2005. 11. 11. 11:37 Page 2 Thank you for choosing an Electrolux Cycloniclite vacuum cleaner. These operating instructions cover all Cycloniclite models. This means that with your specific model, some accessories may not be included. Accessories and safety precautions Before starting Getting the best results Removing the contents of the dust container Replacing the motor filter Replacing the micro filter Cleaning the cartridge filter Cleaning the hose and the nozzle Troubleshooting and customer information Electrical supply instructions WARNING instructions Guarantee 3 4 4 5 5 5 5 6 7 8 9 10 2 z71xx_ifu. qxp 2005. 11. 11. 11:37 Page 3 ACCESSORIES AND SAFETY PRECAUTIONS 1 2 3 Accessories 1. [. . . ] Remove the dust container by using the open button on the handle. Remove the filter set by pushing the button. Remove the protector mesh from the cartridge filter by pulling it out (A). Remove the cartridge filter by turning it counter-clockwise (A) and pull it out (B). Shake the dirt from the filter and the mesh into a bin, if necessary the filter and mesh can be rinsed, with cold water, under a tap. Air dry them for approximately 24 hours, to ensure it is completely dry before re-using. Avoid direct sunlight and extreme drying circustances. If you wish to use your appliance while the cartridge filter is drying, you may use the extra cartridge filter inserted in the packaging box (Z7109, Z7110, Z7119). Insert the cartridge filter into its place (B) and turn it clockwise (A). Insert the protector mesh into its place by pushing it onto the cartridge filter (B). Insert the filter set back into the dust container. Insert the dust container back into the cleaner by pressing it down until it clicks. Cartridge filter reference number: EF75b. Note: Do not use cleaning agents and avoid touching the delicate filter surface. B A A B 7 8 9 10 5 z71xx_ifu. qxp 2005. 11. 11. 11:37 Page 6 CLEANING THE HOSE AND NOZZLE The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked, or the filters are blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters. Then restart the vacuum cleaner. Use a cleaning strip or similiar to clear the tubes and hose. It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. To avoid reduction in suction power, frequently clean the dual purpose floor nozzle. The easiest way to clean it is by using the hose handle. 1 2 3 6 z71xx_ifu. qxp 2005. 11. 11. 11:37 Page 7 TROUBLESHOOTING AND CUSTOMER INFORMATION Troubleshooting The vacuum cleaner does not start 1. [. . . ] If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is double insulated and no earth-connection is necessary. ] It is in you interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of guarantee. As a general guide to fitting any plug · Ensure the lengths of wire inside the plug are prepared correctly. [. . . ]