User manual AEG-ELECTROLUX Z77A

[. . . ] If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre. · To avoid excessive heat and damage to the unit or batteries, do not operate the vacuum cleaner while in the charging stand. · Do not allow to be used as a toy. Close attention is necessary when used by or near children. [. . . ] While charging, the charger may become warm to the touch. This is a normal condition and does not indicate a problem. Important Battery Disposal Information Nickel-Cadmium Batteries Your vacuum cleaner uses nickel-cadmium batteries in a removable pack. To protect our environment, properly dispose of the battery pack when the batteries no longer hold a charge. A municipal waste will not dispose of the battery pack. Ni-Cd NOTE: Remove the battery pack only when the batteries no longer hold a charge and you plan to dispose of them. Service Information The instructions in this booklet serve as a guide to routine maintenance. If additional service is required, telephone the Electrolux helpline on: 08706 055055 Spares New filters can be obtained from Authorised Electrolux dealers and electrical retailers. If difficulty is experienced in obtaining spares please call Electrolux Group on 08706 055055. The motor has lubrication and has a permanent seal. Rating Plate The model number is indicated on the rating plate which is located on the underside of the vacuum cleaner. For prompt and complete service, always refer to these numbers: Model and Type No. ______________________ Serial No. or Date Code___________________ MODEL VOLTS TYPE WATTS Electrolux Made in China SERIAL NO. HERTZ 3 Identify Parts Screws and Cavity Wall Anchors On/Off Switch Charging Light Dust Cup Latch Foam Filter Motor Filter Dust Cup Charging Socket Charger Plug Wall Mount Bracket USING THE VACUUM CLEANER 1. To switch on, move the on/off switch forward towards the dust container. To switch off, move the on/off switch backward towards the handle. How to Wall Mount your Wall Bracket CAUTION: Use only charger model AD-0514-BS1. Your vacuum cleaner has a special bracket designed to hold the unit, so that it may recharge while mounted on the wall. The wall bracket can be positioned whichever way is convenient for the location you have chosen. Mount on a wall where there are no dangerous objects hidden beneath the wall surface like electrical wires, pipes, etc. Hold bracket against wall to mark location for screws. Use a 1/4 inch drill for drilling holes for the plastic anchors. Use a screwdriver to drive the screws into the anchors to secure the bracket. Holes for Screws. Charging Socket 4 How to Mount your Vacuum Cleaner 5. Line the socket charger on the wall bracket up with the receptacle on the back of the cleaner. Push the cleaner against the wall bracket until you hear the charger socket click into place. Plug the charger into an electrical outlet. The charging light will come on, to indicate the vacuum cleaner is charging. Charging Socket Charging Light Electrical Outlet Charger Plug NOTE: Charge the cleaner for 14-16 hours before initial use. [. . . ] Electrolux does not accept liability for all defects arising from neglect, misuse or accident. This guarantee excludes such normal wearing parts as cloths and brushes as the life of these depends upon the amount and nature of use. For further assistance relating to your handheld vac contact Electrolux helpline on 08706 055 055. IMPORTANT: For future reference we suggest you record the following details here, and keep the receipt with the handbook as proof of purchase. [. . . ]