User manual AEG-ELECTROLUX Z8230

[. . . ] Attach the telescopic tube to the hose handle and the floor nozzle (certain models have a lock button that must be pressed before the hose and telescopic tube can be pulled apart). If you have a vacuum cleaner with remote control, make sure that the connector is pressed in completely. Electrolux Twinclean features an automatic cord winder (autoreverse). Pull out the power cord and plug into a socket. [. . . ] After you have made a full turn, the vacuum cleaner turns off and the filter light stops flashing. About once each year, when the filter light begins to flash more frequently, the filters need to be washed. A Lift out the filters according to the above. B Remove one filter at a time from the filter container (29) by pressing the marked release button and turning the filter. C Rinse the filters in lukewarm water and let them dry. D Thread the filters back into the filter holder. The vacuum cleaner automatically stops if there is a blockage in the nozzle, tubes or hose or if the filter or filter holder becomes blocked. Pull out the power plug and allow the vacuum cleaner to cool down for 20­30 minutes. Remove the blockage that is causing the problem, and/or replace the dirty filter. 34 Use a suitable implement to clear the tubes and hose of blockages. 35 It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. Troubleshooting The vacuum cleaner does not start · Check that the cable is connected to the mains. · Check that the plug and cable are not damaged. · Check for a blown fuse. 33 The vacuum cleaner stops If something gets stuck in the vacuum cleaner · Check if Twinclean is full. If so, empty it and clean both the box and the filter before putting it back in the cleaner. · Is the nozzle, tube or hose blocked?· Are the filters blocked? 31 32 34 Water has entered the vacuum cleaner If something gets stuck in the vacuum cleaner: 36 Turn off the vacuum cleaner and open the cover at the front of the unit by lifting the release catch. 37 Lift out the filter holder and the filters. 38 Lift the cover between the filter wells and remove anything that may have got stuck. Also check the bottoms of the filter wells for foreign objects. 39 Refit the cover under the catches and close it by pressing down. Put the filter holder back in place and close the vacuum cleaner cover. It will be necessary to replace the motor at an authorised Electrolux service centre. [. . . ] Clean as required and put them back in the reverse order. 39 40 41 42 Cleaning the Max In Turbo and motorized nozzles Parking position 19 20 When you pause during cleaning, the tube can be attached to the rear of the vacuum cleaner. When storing, the vacuum cleaner can be placed on end and the tube attached at the bottom of the vacuum cleaner. Always unplug the vacuum cleaner from the wall outlet before cleaning. 43 To remove the brush roller cover, push the outer latch out, and the middle cover to the left, and this will also free the wheels for cleaning. 44 Lift out the brush roller and clean it. [. . . ]