User manual AEG-ELECTROLUX Z9124

[. . . ] Without the filters or the front cover in place. Close to construction work with fine dust, for example from plaster, concrete, flour, hot or cold ashes. Without first unwrapping filters Do not put objects on top of or inside of unit. [. . . ] When not using the remote control for an extended period of time, remove the batteries. Keep remote control away from direct sunlight or heaters. Operate the remote control within 6 meters from the air cleaner and facing the air cleaner. Remove objects or furniture that are located between the remote and the air cleaner. Clean unit as necessary by wiping with a dry, soft cloth. Do not use volatile fluids such as benzene and paint thinner, as they may damage unit. Clean the wall behind the air outlet periodically. The HEPA filter should normally be washed every 1/2 year but maximum 6 times equivalent to 3 years of usage. The clean/ replacement period will vary depending on the hours of usage, air quality and location of the unit. Do not wash and reuse Carbon Pre-filter as it will not work effectively. Turn off the unit and remove the front panel by grasping the bottom outside edges and pulling gently toward you (Fig. Pull out the Carbon Pre-filter and the HEPA Filter by grasping the tabs located on each side of the filter (Fig. Wash the HEPA filter acc to image with water only on both sides and leave it to dry for 24 hours (Fig. Only use original filters designed for this unit. Push reset button (8) on inside of unit for 5 seconds until a beep is heard after changing HEPA filter and replace the front panel. Before You Call ­ here are solutions to the most common problems. [. . . ] Turn the unit off and remove the front panel. Press and hold down the reset button on the upper left hand side of the unit for 5 seconds. The unit will beep and the FILTER light will go out. [. . . ]