User manual AEG-ELECTROLUX ZB274

[. . . ] Replace the hatch cover. CLEANING THE WHEELS CLEANING THE BELLOWS 1 If the wheels needs to be cleaned, remove them carefully by using a small screwdriver. 2 Remove objects that have become jammed in the wheel shafts. Reassemble the wheels by pressing them back into their tracks. 1 Occasionally objects can get stuck in the bellows, and this can affect suction power. Clean the bellows after removing the dust cup. 6 DISPOSAL REMOVING BATTERIES Only remove batteries if product is to be scrapped. 1 Run batteries fl at and disconnect UniRapido from the charging station Undo the 11 screws (2 of them hidden under the release button). 2 Release the button and carefully lift the hood. 3a Unclip the connecting cables and lift out the batteries Batteries should be removed from the appliance before it is scrapped. 3b Unclip the connecting cables and lift out the batteries Batteries should be removed from the appliance before it is scrapped. Used batteries should always be taken to a recycling Station. 7 SAFETY PRECUATIONS UniRapido should only be used by adults and only for normal vacuuming in adomestic environment. Make sure the vacuum cleaner is stored in a dry place. [. . . ] Children should be supervised to ensure that they do not play with the appliance. Each vacuum cleaner is designed for a specific voltage. Check that your supply voltage is the same as that stated on the rating plate. Use only the original charging adaptor designed for this model. Never use the vacuum cleaner · · · · · · · · · · In wet areas. When housing shows visible signs of damage. On hot or cold cinders, lighted cigarette butts, etc. On fine dust, for instance from plaster, concrete, flour, hot or cold ashes. Do not leave the vacuum cleaner in direct sunlight. Avoid exposing the vacuum cleaner or battery to strong heat. The battery must not be dismantled, shortcircuited, placed against a metal surface or exposed to strong heat. Without filter. Using the vacuum cleaner in the above circumstances may cause serious damage to the product. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. [This cleaner is double insulated and no earth-connection is necessary. ] It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of guarantee. Connecting to your electrical supply Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse and the fuse cover must be replaced before the plus is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux dealer or Electricity Board and must be of the same colour as indicated by the coloured insert on the base plug. If difficulty is experienced in obtaining a replacement, contact your nearest Electrolux Service Centre. (Please see the separate Electrolux Service Organisation leaflet). As a general guide to fitting any plug · · · · · Ensure the lengths of wire inside the plug are prepared correctly. Connection should be firmly made after all conductor stands are entered into the terminal posts. When preparing the cable ends take care not to damage the outer seal, or insulation surrounding the inner conductors. Replace the top cover of the plug and secure. In no circumstances must the plug be used without a correct fuse cover fitted. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. The cut off plug should then be disposed of to prevent hazard of shocks in case it should be plugged into a 13 Amp socket in another part of your home. The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. [. . . ] You may be required to take the product to your nearest service provider if the product requries attention during the first year. There are certain conditions which may invalidate this guarantee: a. It is dependent upon the appliance being correctly installed and used in accordance with the Company's instructions under normal domestic conditions within the United Kingdom or the Republic of Ireland. Service at all times must be carried out by an Electrolux Service Representative or authorised agent. [. . . ]