User manual AEG-ELECTROLUX ZB2812

[. . . ] The appliance is not intended for use by young children and infirm persons without supervision. Use only the original charger designed for this model. When housing shows visible signs of damage. [. . . ] Attach the crevice nozzle to the vacuum cleaner to facilitate cleaning of areas difficult to reach or attach the brush for dusting. Ergorapido's dust container must be emptied when it's full. Every now and then the dust container and the filters need to be cleaned to maintain a high suction power. Vacuum clean the dust container by placing the hose handle of another vacuum cleaner against the vacuum cleaning hole. Release the whole dust container by pushing the release button (29a), remove the filters and empty the contents into a wastepaper basket (29b). Return the filters and press back the dust container until it clicks into place. Quick cleaning of the fine filter (recommended every third cleaning) 30. If Ergorapido seems to have a low suction power the fine filter might need to be cleaned. Release the whole dust container by pressing the release button (29a). Pull and release the spring for filter cleaning (30a) 5-6 times to free dust from the filters. It's important to release the spring completely from its outer position. Release the whole dust container by pushing the release button (29a). Take out both filters by pressing the release buttons, as shown in the image (31). The dust container, prefilter and fine filter can be shaken clean or cleaned and rinsed using luke warm water (32b). Make sure that the parts are dry before they are reassembled. If the brush roll becomes blocked or jammed for any reason, the indicator light (33a) on the floor nozzle will go out. [. . . ] Com If you have any comments on the cleaner or the Instructions for Use booklet please e-mail us at: floorcare@electrolux. We declare that this battery operated vacuum cleaner, intended for domestic use, conforms to the EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC with amendment 90/683/EEC and the CE marking Directive 93/68/EEC. All conformity testing has been done by an independent third party testing body. [. . . ]