User manual AEG-ELECTROLUX ZCV750E

[. . . ] NOTE: The cloth filter must remain in place even if the paper filter bag is used. Wrap a large garbage bag around the lower portion of the power unit and hold firmly in position. Grasp the cloth filter through the plastic bag and shake vigorously. Carefully remove the plastic bag from the unit and discard. [. . . ] Never handle plug, cord, or power unit with wet hands. Electric shock could occur if used on wet surfaces. Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present. "Connect to a properly grounded outlet only. See grounding instruction. " Empty the Dirt Bucket (ZCV750E, ZCV783, ZCV784) The ZCV750E is equipped with a self-cleaning cloth filter. The dirt and debris is collected in the detachable dirt bucket. Models which do not use a paper bag must have the dirt removed from the dirt bucket. Release the clamps or turn the bucket to the left. Brush the filter while the bucket is off the power unit. Return the bucket to the power unit and secure. Be sure the bucket is securely attached to avoid any suction leakage. Replace Paperbag Filter (ZCV781) The ZCV781 is equipped with a paperbag filter. WIRING: Check local codes but use not less than #14-2 with ground wire. Connect power unit cord to appropriate electrical circuit. Be sure line voltage is sufficient to handle 10 amp load. · · · · · Plug the hose into each inlet valve to be sure the electrical contacts operate properly. Check each pipe connection for air leaks. Be sure the paper bag and filters are properly installed in the power unit. Your cleaning system is ready to use. WARNING Improper connection of an equipment-grounding conductor can result in risk of electric shock. Check with qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the appliance. If it will not fit the outlet, have proper outlet installed by a qualified technician. This appliance is for use on a nominal 230/240 V circuit and has a grounded plug. [. . . ] An obstruction in the inlet valve may cause the power unit to continue to run after the hose is removed from the inlet. Check all the inlet valves and remove any obstruction to shut down the power unit. When unplugging the hose from the inlet valve, hold the inlet cover open for a few seconds to allow the suction to decrease and protect the inner seal. 2 5 Planning If your home already has the system of plastic pipes and inlet valves, you are ready to install the power unit (refer to Install Power Unit sections, below). If not, you can contract to have the system installed by a professional or you may choose to do-it-yourself. [. . . ]