User manual AEG-ELECTROLUX ZCV782

[. . . ] If no visual obstruction can be detected, disconnect the cleaner from the power receptacle and contact your nearest Electrolux service location. 8 Instruction Manual (Swedish) (Danish) (Norwegian) (Finnish) P/N 460332 SVERIGE Electrolux Central Vacuum Systems 4. 5. Rotate the bag collar 45° counter clockwise so the bumps on the adapter DO NOT align with the collar bump cutouts. To remove, rotate the bag collar 45° clockwise and gently lower the collar off of the bag adapter. Cloth Filter Cleaning (ZCV782, ZCV783, ZCV784) NOTE: Disconnect power cord from electrical outlet before cleaning the filter. [. . . ] The paperbag filter is located in the top end of the power unit. To remove the paperbag filter, detach the lid of the power unit by twisting it and removing it. The paperbag can be taken off and disposed of. A new filter paperbag is put in place and the lid securely attached again with a twist movement. Be sure the paperbag and the lid are securely attached to avoid any suction and dirt leakage. Filter and Disposable Paper Bag Reduced airflow or suction indicates the central vacuum cleaner is not operating at maximum efficiency. If the disposable paper bag is full or a filter is clogged, no air can pass through the unit and no cleaning will take place. Remove and dispose of the paper bag. Do not operate this unit without all filters in place. Optional DISPOSABLE PAPER FILTER BAG WITH CLOTH FILTER (cannot be used with dual intake/intake-utility installations) NOTE: Disconnect power cord from electrical outlet before cleaning the filter. The elbow with the paper bag adapter must be installed, in the body facing downward as shown for the paper bag. Using pipe clamp, attach 90º sweep with bag adapter to 45º intake fitting as shown. Can only be used with single intake installations. Hold the bag collar with fingertips and align the bumps on the adapter with the bump cutouts in the collar. Insert adapter and push the bag collar all the way up to the lip on the elbow. SAVE THESE INSTRUCTIONS 1 6 Grounding Instructions This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor. The cord must be connected to an appropriate circuit that is properly installed and grounded in accordance with all local codes and ordinances. (The Model ZCV781 is double insulated, therefore not applicable. ) Connect the two low voltage terminals, as shown in Figure A, to the power unit and to the wires installed with the main trunk line. It is recommended you secure other connections with wire nuts. Be certain you comply with your local electrical codes and regulations. Plug the cord into a grounded receptacle as shown and into the power unit control module as shown in figure B. You are now ready to check the installation of the unit. WARNING: Electric shock could occur if used on wet surfaces. WIRING: Check local codes but use not less than #14-2 with ground wire. [. . . ] If the mounting bracket cannot be mounted on the stud, it is suggested you use a length of board mounted horizontally to the studs. Drill mounting holes to start screws. 1-stage TF 135 mm Model ZCV781 592 x 414 mm You are now ready to install the power unit. Be sure the power unit will be located at least 30 cm from the ceiling and any adjacent wall and at least 70 cm from the floor. The motor hood ventilation should never be obstructed. [. . . ]