User manual AEG-ELECTROLUX ZCX6202

[. . . ] 1 Insert the hose until the catches click to engage (press the catches to release the hose). Insert the hose into the hose handle until the catches click to engage (press the catches to release the hose). 1 Attach the extension tubes* or telescopic tube* to the hose handle and nozzle by pushing and twisting together. (Twist and pull apart to dismantle. ) 1 Extend the electric cable and connect it to the mains. [. . . ] 17a Start the vacuum cleaner by rotaring the power control in the direction of the "Max" position. Increase suction power by rotaring the control further up to "Max" position. Stop the vacuum cleaner by rotaring in the opposite direction to "Off" position. In order to achieve an optimal cyclone effect in the cleaner, the power regulation should always be in the "Max" position. 17b* Suction power can also be adjusted by using the suction control on the hose handle. 18 Ideal parking position for pausing (18a) and storing (18b). Before starting 11 11 12 13 14 15 16 Electrical cable precautions: Regularly check that the cable is not damaged. Never use the vacuum cleaner if the cable is damaged. Damage to the machine's cable is not covered by the warranty. 8 17a 17b 9 10 * Certain models only. * Certain models only. 18a 18b Getting the best results Use the nozzles as follows: Carpets: Use the combination floor nozzle with the lever in position (19). Hard floors: Use the combination floor nozzle with the lever in position (0). Wooden floors: Use the parquet nozzle* (1). 19 20 Emptying and cleaning the dust container CycloneXL's dust container must be emptied when it is full. 7 Pull the release button at the rear of the vacuum cleaner. EF H1W) The filters must always be replaced with new ones and cannot be washed (except the Hepa H1* washable). 7 8 Open the back lid and lift out the filter. Insert a new filter and close the lid. 34 Note: The warranty does not cover any damage to the hose caused by cleaning it. Cleaning the floor nozzle Be sure to frequently clean the combination floor nozzle. * Press each wheel-hub and draw away the wheels. Remove dust-balls, hair or other objects that may be entangled. * Larger objects can be accessed by removing the connection tube from the nozzle. 41 42 35 Cleaning the turbo nozzle* Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads, etc. Use the hose handle to clean the nozzle. 6a Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads, etc. Use the hose handle to clean the nozzle. 6b In case the turbo nozzle stops working, open the cleaning lid and remove any objects that obstructs the turbine to rotate freely. [. . . ] · Check whether the dust container is full. · Is the nozzle, tube or hose blocked?· Are the filters blocked? The vacuum cleaner stops Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorised Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. Consumer information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. [. . . ]