User manual AEG-ELECTROLUX ZE2248

[. . . ] 13 Insert the hose until the catches click to engage (press the catches to release the hose). 3* Insert the hose into the hose handle until the catches click to engage (press the catches to release the hose). 14 Attach the extension tubes* or telescopic tube* to the hose handle and nozzle by pushing and twisting together. (Twist and pull apart to dismantle. ) 15 Extend the electric cable and connect it to the mains. [. . . ] · When housing shows visible signs of damage Never vacuum: · Sharp objects. · Fluids (this can cause serious damage to the machine). · Hot or cold cinders, lit cigarette butts, etc. · Fine dust, for example from plaster, concrete, flour, hot or cold ashes. The above may cause serious damage to the motor ­ damage which is not covered by the warranty. Electrical cable precautions: · A damaged cable should only be replaced by an authorised Electrolux service centre. · Damage to the machine's cable is not covered by the warranty. · Never pull or lift the vacuum cleaner by the cable. · Disconnect the plug from the mains before cleaning or maintenance of the vacuum cleaner. · Regularly check that the cable is not damaged. Never use the vacuum cleaner if the cable is damaged. Use the nozzles as follows: Carpets: Use the carpet/hard floor nozzle with the lever* in position (32). 29 Reattach the filter holder containing the new filter(s). 27 Replace the insert holding the s-bag® and then close the cover. B Model with exhaust filter Follow steps 24, 28 and replace old motor-filter with a new one. Replacement of the exhaust filter* There are three types*** of exhaust filter: · Microfilter* (Ref. EF 17) · Hepa H12* non washable (Ref. EF H12) · Hepa H12*/*** washable (Ref. EF H12W) The filters must always be replaced with new ones and cannot be washed (if not mentioned). 30 Place your thumbs on the back edge of the lid and then open the lid by pulling the handle backwards and upwards with your index/middle finger. Insert a new filter and replace the lid as shown. balls, hair or other objects that may be entangled. Replace the wheel by pressing them onto the axles. 37* Larger objects can be accessed by removing the connection hose from the nozzle (press the small catches located on each side and simultaneously draw the connection tube outwards in an upright position). [. . . ] However, be careful in case the obstruction is caused by glass or needles caught inside the hose. Consumer information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. This product is designed with the environment in mind. All plastic parts are marked for recycling purposes. For details see our web site: www. electrolux. com If you have any comments on the cleaner or the Instructions for Use booklet please e-mail us at: floorcare@electrolux. com If you can´t find dustbags or accessories to your Electrolux vacuum cleaner, please visit our website at www. electrolux. com. Note: The warranty does not cover any damage to the hose caused by cleaning it. Cleaning the floor nozzle 39 To avoid deterioration of suction power, frequently clean the carpet/ hard floor nozzle. [. . . ]