User manual AEG-ELECTROLUX ZE331A

[. . . ] Please remove the plug from the socket outlet before cleaning or maintaining the appliance. When housing shows visible signs of damage. On fine dust, for instance from plaster, concrete, flour, hot or cold ashes. [. . . ] It can be used with brush up on all surfaces for maximal convenience with maintained excellent dust removal result. The brush setting should be used to reach optimal dust removal even on difficult hard floors or to get a combing effect on carpets. * Use the carpet/hard floor nozzle with lever in position (22). Note: Do not use the turbo nozzle on skin rugs, rugs with long fringes or a pile depth exceeding 15 mm. to avoid damaging the carpet , do not keep the nozzle stationary whilst the brush is rotating. Do not pass the nozzle across electric cables, and be sure to switch off the vacuum cleaner immediately after use. 25 The dust bag must be replaced latest when the indicator window is completely red. 26 27 Open the front cover and lift out the insert holding the s-bag®. Pull the cardboard to remove the s-bag® from the insert. this automatically seals the s-bag® and prevents dust leaking out. Insert a new s-bag® by pushing the cardboard right into the end of the groove in the insert. Put the insert back into the bag compartment, and close the cover. Replace the s-bag® even if it is not full (it could be obstructed). also replace after vacuuming carpet-cleaning powder. Be sure to use only an original Electrolux dust bags, s-bag® Classic, s-bag® Clinic Anti-Allergy, s-bag® Classic long performance or s-bag® Anti-odour. The more often the better for the efficiency of the cleaner. [. . . ] disconnect the nozzle from the vacuum cleaner tube and remove entangled threads , etc. Use the hose handle to clean the nozzle. Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. [. . . ]