User manual AEG-ELECTROLUX ZE360WP

[. . . ] Damage to the machine's cable is not covered by the warranty. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Please remove the plug from the socket outlet before cleaning or maintaining the appliance. Never use the vacuum cleaner: · · · · · · In wet areas. [. . . ] 19 Keep the hose in place while storing the vacuum cleaner by extending the elastic bumper cord and placing it across the hose. * Certain models only. 7 2193584-02Outline. indd 7 10/17/08 1:58:21 PM 20 21 22 23 24 5a 5b 5c 8 7 25 8 2193584-02Outline. indd 8 10/17/08 1:58:22 PM English Getting the best results. 20 Accessories on board 3 in 1 multi tool nozzle to be found in the back of the cleaner. Use the nozzles as follows: Carpets: * Use the carpet/hard floor nozzle with lever in position (21). * On the Dust Magnet nozzle (23 and 24) there is normally no need to switch mode. It can be used with brush up on all surfaces for maximal convenience with maintained excellent dust removal result. The brush setting should be used to reach optimal dust removal even on difficult hard floors or to get a combing effect on carpets. Hard floors: * Use the carpet/hard floor nozzle with lever in position (22). Wooden floors: * Use the parquet nozzle (8). Upholstery: Curtains, lightweight fabrics etc. : Use the upholstery function of the 3 in 1 multi tool nozzle (5a). Frames, bookshelves, etc. : Use the dusting brush function of the 3 in 1 multi tool nozzle (5b). Crevices, corners, etc. : Use the crevice function of 3 in 1 multi tool nozzle (5c). * Using the turbo nozzle (7) Note: Do not use the turbo nozzle on skin rugs, rugs with long fringes or a pile depth exceeding 15 mm. To avoid damaging the carpet, do not keep the nozzle stationary whilst the brush is rotating. Do not pass the nozzle across electric cables, and be sure to switch off the vacuum cleaner immediately after use. 25 The dust bag must be replaced latest when the indicator window is completely red. Read with the nozzle lifted up. * Certain models only. 9 2193584-02Outline. indd 9 10/17/08 1:58:23 PM 26 29 27 28 30 31 32 33 34 10 2193584-02Outline. indd 10 10/17/08 1:58:24 PM English Replacing the dust bag, s-bag® 26 27 Open the front cover and lift out the insert holding the s-bag®. Pull the cardboard to remove the s-bag® from the insert. This automatically seals the s-bag® and prevents dust leaking out. Insert a new s-bag® by pushing the cardboard right into the end of the groove in the insert. Put the insert back into the bag compartment, and close the cover. 28 29 Note. Replace the s-bag® even if it is not full (it could be obstructed). Also replace after vacuuming carpet-cleaning powder. Be sure to use only an original Electrolux dust bags, s-bag® Classic, s-bag® Clinic Anti-Allergy, s-bag® Classic long performance or s-bag® Anti-odour. Replacement of the filter(s) The more often the better for the efficiency of the cleaner. [. . . ] · Is the nozzle, tube or hose blocked?· Are the filters blocked? Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorised Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. Consumer information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. This product is designed with the environment in mind. [. . . ]