User manual AEG-ELECTROLUX ZO6327

[. . . ] 5 ADJUSTING AIR FLOW DIRECTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 HOW THE AIR CONDITIONER WORKS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 OPTIMAL OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] DEFROST Indicator (For cooling& heating model only): The air conditioner starts defrosting automatically if outdoor unit frosts in heating operating. At this time, DEFROST Indicator illuminates. DISPLAY PANEL NOTE: The display panel on the indoor unit would look like as following: 14 Infrared signal receptor 16 AUTO indicator: This indicator flashes when the air conditioner is in AUTO operation. 17 DIGITAL DISPLAY : Displays the current setting temperature when the air conditioner is in operation. 13 TIMER AUTO POWER DEFROST Note: 15 16 17 All the pictures in this manual are for explanation purpose only. They may be slightly different from the air conditioner you purchased. The actual shape shall prevail. 4 OPERATING TEMPERATURE Mode Temperature Room temperature Outdoor temperature Cooling operation 17 C~ 32 C ( -5 C 43 C:For the models with ~ low temperature cooling system) Heating operation 0 C ~ 30 C -7 C~ 24 C Drying operation 17 C~ 32 C 11 C ~ 43 C 18 C ~ 43 C CAUTION: 1. If air conditioner is used outside of the above conditions, certain safety protection features may come into operation and cause the unit to function abnormally. If the air conditioner operates in excess of this figure, the surface of the air conditioner may attract condensation. Please sets the vertical air flow louver to its maximum angle (vertically to the floor), and set HIGH fan mode. Optimum performance will be achieved within these operating temperature. MANUAL OPERATION Manul operation can be used temporarily in case you can not find the remote controller or its batteries are exhausted. Open and lift the front panel up to an angle until it remains fixed with a clicking sound. 2 Push the button until the AUTO indicator is lit, the unit will work in forced AUTO mode (the default setting temperature is 24 ). If the AUTO mode is uncomfortable, you can select desired conditions manually. operation starts ECONOMIC Operation ECONOMIC OPERATION When you push ECONOMY button during cooling, heating (cooling only type without), or AUTO operation , the air conditioner will start following operation . The fan speed will be automatically controlled . In the operation suppression zone where capacity is kept to the minimum , overcooling is prevented by raising the temperature setting by 1 after 1 hour and by 2 after 2 hours of operation. Remove the AIR FILTER from the indoor unit. Clean the AIR FILTER once two weeks. Filter Handle Clean the AIR FILTER with a vacuum cleaner or water, then dry it up in cool place. 8 MAINTENANCE 4. Remove the air freshening filter from its support frame (The installation and removing method of the air Air freshening filter freshening filter is different depending on the models, see the pictures marked and on the left. Clean the air freshening filter at least once a month, and replace it every 4-5 months. Clean it with vacuum cleaner, then dry it in cool place. Install the air freshening filter back into position. Insert the upper portion of air filter back into the unit taking care that the left and right edges line up correctly and place filter into position. Air freshening filter Maintenance If you plan to idle the unit for a long time, perform the following: (1) Operate the fan for about half a day to dry the inside of the unit. (2) Stop the air conditioner and disconnect power. Remove the batteries from the remote controller. [. . . ] Adjust the horizontal louver to the maximum air outlet position and select HIGH fan speed. Heating mode (For cooling and heating models only) The air conditioner draws in heat from the outdoor unit and releases it via the indoor unit during heating operation. When the outdoor temperature falls, heat drawn in by the air conditioner decreases accordingly. At the same time, heat loading of the air conditioner increases due to larger difference between indoor and outdoor temperature. [. . . ]