User manual AEG-ELECTROLUX ZUSG3901

[. . . ] Insert the hose (to remove it, press the lock buttons and pull the hose out). Insert the hose into the hose handle until the catches click to engage (press the catches to release the hose). Attach the telescopic tube to the floor nozzle (to remove it, press the lock button and pull the nozzle off ). ) Click Attach the telescopic tube to the hose handle (to remove it, press the lock button and pull the hose handle out). [. . . ] Tap the filter frame to remove the water. Note: Do not use cleaning agents and avoid touching the filter surface. 12 h In room temperature) before putting back !We recommend to change the the washable filter also at least once in a year or when it is very dirty or damaged. Open the filter lid by pushing the two buttons simultaneously under the handle. use Electrolux original filters: EFH12 , EFH12W , EFH13W. Lift out the filter and check the color of the frame: Blue colored = Washable exhaust filter Green colored = Non washable exhaust filter (it must be replaced by a new one) cn tw . Ind thai viet Replacing the motor filter thai When the filter has been replaced, the filter lid can be pushed back until the two buttons click in. If the filter lid comes loose, restore by positioning the two hinges at the bottom and push the filter lid back until both delete of the two buttons click in. Replace the motor filter when dirty or after every 5th s-bag®. Push the filter holder down and pull it out. 14 Cleaning the nozzle Disconnect the nozzle from the tube. Use the hose handle to clean the nozzle. If the wheels are stuck, clean them by removing the wheel cap (only at the AeroPro nozzle) with a small screwdriver. Unscrew the wheel axis and clean all parts. Cleaning the motorized nozzle Always disconnect the nozzle before cleaning it !Open brush roll cover by pushing the latches. This will free the front wheels for cleaning. Pull out the brush roll and remove entangled threads by snipping them away with scissors. Use the hose handle to clean the nozzle. If the wheels are stuck, remove them carefully by using a small screwdriver. Cleaning the Turbo nozzle (certain models only) ( ) 15 eng kor Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads, etc. [. . . ] Never pull or lift the vacuum cleaner by the cord. all servicing and repairs must be performed by an authorized Electrolux service centre. Store the vacuum cleaner in a dry place. Cn tw ind thai viet Consumer information and sustainability policy Electrolux declines all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. [. . . ]