User manual AEG-ELECTROLUX ZV1030

[. . . ] · , . · · · · Never vacuum: Sharp objects, fluids. Hot or cold cinders, lit cigarette butts, etc. Fine dust, for example from plaster, concrete, flour, hot or cold ashes. The above may cause serious damage to the motor ­ damage which is not covered by the warranty. [. . . ] 17c* If you have a vacuum cleaner with remote control, press the +/- buttons to adjust suction control (be sure batteries have been inserted beforehand). You can also start/stop the cleaner by pressing the centre of the control (as long as the main cleaner switch is set to on). 18a Practical on/off Power Clip, the Power Clip automatically turns the vacuum cleaner off when nozzle/tube is placed here. Ideal parking position for pausing and (18b) storing, P s-bag® ( )* *. (18b) . * . 11 * Certain models only. 5 3/31/05 3:02:02 PM 2191133-05. indd 5 English Getting the best results Use the nozzles as follows: Carpets: Use the combination floor nozzle with the lever in position (19). Hard floors: Use the combination floor nozzle with the lever in position (20). P : Wooden floors: Use the parquet nozzle* (21). Upholstered furniture and fabrics: Use the upholstery function of the small combination nozzle* (22a)/ upholstery nozzle* (23) for sofas, curtains, lightweight fabrics etc. Frames, bookshelves, etc: Use the dusting brush function of the small combination nozzle* (22b). Crevices, corners, etc. : Use the crevice nozzle* (24). Using the turbo nozzle* 25 Ideal for carpets and wall-to-wall carpeting to remove stubborn fluff and pet hairs. 26 Adjust the suction power by opening or closing the air vent. : , (19). : * (22a) * (23) , , . EF 17) · Hepa H12* non washable (Ref. EF H12) · Hepa H12* washable (can be bought as an option, Ref. B 32­34 . * : · * ( EF 17); · Hepa H12* ­ ( EF H12) · Hepa H12* ( , EF H12W); ( Hepa H12*). . The filters must always be replaced with new ones and cannot be washed (except the Hepa H12* washable). 35 Open the back lid and lift out the filter. Insert a new filter and close the lid. 8 2191133-05. indd 8 * Certain models only. * . 3/31/05 3:02:13 PM English Cleaning the hose and nozzle The vacuum cleaner stops automatically if the nozzle, tube, hose or filters and s-bag® becomes blocked. In such cases, disconnect from mains and allow to cool for 20-30 minutes. Clear blockage and/or replace filters and s-bag® and restart. P , , , s-bag® . / s-bag®, . Tubes and hoses 36 Use a cleaning strip or similar to clear the tubes and hose. 37 Hose handle could be dismantled from hose if cleaning is needed. 38 It may also be possible to remove the obstruction in the hose by squeezing it. [. . . ] Do not throw away the batteries with household waste. Discard of them in special recycling containers and heed local regulations. Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorised Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. * , . [. . . ]