User manual AEG AP 250 ECP

[. . . ] Close the nozzles or suction hose opening with the palm of your hand. Use only AEG accessories and spare parts. Should components need to be exchanged which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). [. . . ] Never suck up into the machine any inflammable or explosive solvents, or liquids like petrol, oil, alcohol, thinners, or small particles (such as metal filings or ash) that may be hotter than 60°C - otherwise there is danger of explosion or fire!You are not allowed to use the appliance in the vicinity of inflammable gases or substances. Do not put appliances or accessories into operation, if: the appliance has recognizable damage (cracks/breaks), the mains connection lead is defective or shows signs of cracking or aging, there is a suspected non-visible defect (after having been dropped). Do not point the nozzle, hose or tube at people or animals. The plug socket on the appliance may be used only for the purposes defined in the usage instructions. If any foam or water egresses, switch off immediately. Empty the container and, if need be, the pleated filter. acids , acetone and solvents can corrode the appliance components. In the event of misuse, improper operation or unprofessional repair work no liability shall be assumed by us for any damage incurred. Do not use suction on health damaging dusts. Not suitable for sweeping up liquids which form a large foam. Make sure that the mains connection cable is not damaged, squashed, bent, or damaged by being run over or in any other way. if the mains connection cable is damaged the machine must not be used. Have the faulty mains connecting lead replaced by your AEG service representative or a qualified electrician prior to using the appliance again. Extension cables to the mains must at least be protected from water spray and contain an earth lead. This tool is not intended for use by persons (including children) with limited physical, sensory or mental capacities or insufficient experience and/or knowledge unless they are supervised by a person who is responsible for their safety or have been instructed by them in the safe use of the tool. [. . . ] Follow the operating instructions and safety instructions for appliances connected to the power tool socket. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents: EN 50366, EN 60 335-2-2, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3, in accordance with the regulations 2006/95EC, 2004/108/EC Please read the instructions carefully before starting the machine. Always disconnect the plug from the socket before carrying out any work on the machine. [. . . ]