User manual AEG BS2E 12 T

[. . . ] J Remove the battery pack before starting any work on the machine. J Do not dispose of used battery packs in the household refuse or by burning them. Atlas Copco Distributors offer to retrieve old batteries to protect our environment. J Do not store the battery pack together with metal objects (short circuit risk). [. . . ] Variable torque pre-selection at adjustment ring for correct screwing depth when working with different screws or different material. Switch trigger for switching the machine on and off, and for smooth starting and varying speed. QUICKSTOP ­ the speed of the working spindle is immediately reduced when releasing the switch. Reversing lever for changing from forward to reverse rotation ­ due to a lockout mechanism, switching the lever is only possible if the On-/Off switch is not depressed. Powerful battery pack with reverse battery protection, negative and positive pole cannot be mistaken. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. The chuck is easier to remove when 1st gear is engaged as the gears tend not to rotate as easily. Inserted Allen key lightly with a plastic hammer. Otherwise thchuck might become loose in anti­clockwise operation. Battery pack Battery pack reception (only applicable for BS2E 12 T BS2E 14. Fully charge new or long stored battery packs before using your battery tool. Battery packs only reach full capacity after 4 ­ 5 chargings. Insert the battery pack from behind into the machine until it engages (as shown in illustration). The battery pack can be inserted either way into the holding device: From the front: The shape of the machine is more compact and therefore well suited for working in restricted space. From the back: Due to the optimum weight distribution the machine is ideally balanced. This protects the wrist when driving screws or drilling horizontally. Press together the clamps and remove the battery pack in direction of arrow. Due to a lockout mechanism, the reversing lever can only be switched when the On-/off switch is not depressed. The gears can be changed when the machine is switched off or is running under no load. The chuck can be used for drill bits or screwdriver bits. Switching on: Press on-off switch Switching off: Release on-off switch The speed can be infinitely varied by slowly releasing/pressing the switch trigger. For drilling twist the adjustment ring such faces the marking; the that the symbol safety clutch is now locked and the maximum torque available. [. . . ] The battery can be stored permanently in the charger without the danger of being overcharged. The battery charger can be used either standing up or fixed to a wall (see illustration). Battery too cold (less than 0oC) Maintenance charging until battery temperature is above 0oC Battery too hot (over 45oC) Maintenance charging allow battery to cool down below 45oC, and re-insert New battery packs reach full loading capacity after 4 ­ 5 chargings and dischargings. Battery packs which have not been used for some time should be recharged before use. [. . . ]